Sounds like a concensus. I will get in touch with him.

West Coast, in Idaho.

I think I might be in need of a good repair shop. I just lost the right channel on my high frequency MS2125. If it doesnt turn out to be a loose wire, I will need to send the amp in for repair.

Who do I send it to?

Jeff

note to self... find Marko's address and visit the UK in the dead of night.

I would be very wary of any attempt to glue or melt this crack back together. Glue or welding would change the characteristic of the plastic in the area around the repair. This could color the sound of the speaker, or probably just end up breaking again after trying to vibrate at 30Hz for a while. T...

There are several custom plastic dealers around here that could probably pull that off. Any chance of some measurements? Inside diameter and wall thickness?

there are probably better materials to replace that with than Plexi, actually.

True... the cheapest I found was $25 from the local dealer and aout $20 on fleabay..

Since my dad is a phone repairman, all I need to buy is the pots. Digikey has them for like .65 each and I need parts to build my RNET's as well so...

J

Thanks for the link. Thats where I got the pot value, but it doesnt really saw what taper the pot is, or anything like that.

One for the midbass 8's and one for the sub... I have both a 204A and 406A in my system.

So I just want to make sure I am not missing anything here. I need to build 2 LPL's for my setup and I dont see the point is spending $25 on one. I will need for each one: 50.0k ohm potentiometer - rotary logarithmic, 1/5 watt, 20% RJ11 4 pin telephone connector 2 pair telephone cable Solder the cab...

two sets of MBQ 6' and tweet components, 8" midbass under each front seat and the ND15 in the rear deck. I guess I consider it simple because of the install. Its very straight forward with no complicated wiring or anything. No DOLBY processors to tune, no time alignment or anything complated. J...

It should be pretty simple I think. Active 4 way system. No passive crossovers and full frequence response.

J

I just wanted to post my new system setup and see if anyone has any comments. I plan on documenting the install and posting pics as I go. I am open to any comments and suggestions. I would love to hear comments specifically if you have used the same components that I have. All of the crossover point...