So the TR7 didn't do the trick for the remote turn-on solution... very frustrating. Would love some help from the forum on their success with the RF360 install in a 3rd gen Acura TL in getting a remote turn-on solution

computerjlt, thanks again for the info on the turn-on option with the 360. It is configured to turn the amps on so I think they have set the jumpers for that properly. the issue is that the OEM HU does not have enough output voltage to turn the 360 on, the 360 is wired to come on when the key is tur...

where'd you used to work??? I wish it were close to me so I could get the same vibes. Not sure what he's going to charge fr the PAC, but its MSRP on PAC site is $35. He did charge me less than MSRP for some other stuffI needed. I agree on the filters=bandaids but I think we've covered all possible a...

Any in RI, MA or NH??? If a dealer has the AAMP lines (Stinger, PAC) that they can do PG too?

Good points ttocs... i did buy the 360 and cables from them along with sound deadening mat'l and a custom built sub box as part ofthe original install. They only charged me $30 for over an hour of diagnosing including trying other filters. i'm hoping that that PAC unit will allow them to lower any g...

yes, that's in the works, thanks. I already brought it back once, paid for the time to diagnose...still a problem. Goind back next week to have a PAC TR-7 installed to hopeflly cure the system being on when the radio is off (due to a low voltage signal from the factory head unit, the 360 and amps ar...

Thanks! I have been researching the crap out of this and the gains were my next place to target along with the jumper setting in the 360. I appreciate it. I'll let you know how it turns out.

the factory amp has been removed. the set-up is: Factory head unit to RF where the factory amp was (not sure if they cut the factory harnes or had an adapter plug), sheilded/twisted-pair Stinger RCAs to amps in trunk. There is a ground-loop isolator in the line there somewhere. the noise is still pr...

sorry..i should have noted that the 360 is in the front pass kick panel, where the factory amp was. they tied in from teh radio to the 360 then RCA'd to the amps in the trunk. the amps are mounted on a wooden panel and they are grounded in the trunk.

i think they tapped in at the factory amp end of the harness. We've unplugged the RCAs between the 360 and the amps and the noise is still there, so it looks like its def the amps.

I didn't wire it, the shop did...but I did ask them about the 3Sixty being on when the HU is off, and they agree with the topics I've read all over the ent about a lack of remote turn on, and the HU provides too low a voltage to act as one too... the RF unit powers up as soon as the key is turned. I...

I'm looking for help or an amp(s) to power the following: 1 pair of Front A/D/S seperates and a center coax (ideal power is 70-100 w/ch) 1 pair of Rear JL Coax (ideal power is 50w/ch) 1 pair Subs (4 ohm 12" RF that handle 200nom/400peak). I currently have it set up with an ADS PH15 running the ...