so much better thanks again guys!

Sweet thanks so much guys!!!! Ill rewire tomorrow and let you know how it turns out.

Ok that makes sense then. Thanks guys. been along time since I have wired up a system. any diagrams on here I could follow to wire them? I feel like a ass for asking.

I know this is an old thread but I have a 1995 S350 turbo diesel with 650,000 kms on it. biggest issue I had was I needed to replace the timing chain since it has high miles. and its starting to rust. I also have the 96 S600 with the V12 imported from Japan. Sold the engine and trans with 120,000 on...

what would be the best way to wire up the amp and my subs? I Have the Ti 1000.2 and have two xenon 10D4 subs

I should also mention I am only running 4 gauge right now and at idle in traffic with music turned up I get low on my voltage display. Im upgrading to 0 gauge soon.

I have it bridged at 2ohm

Ok I bought this amp about a year ago on here from a good member. Now I just hooked it up now in my F250. I have it mounted under the rear seat like most other truck owners do. Now after 10 mins or so it will shut down for 30 seconds or so then come back on. I felt it and it was really hot. I now ha...

could just tie the new LEDs into the ones that are there already. I think there are 3 in each amp that are blue

my friend works in a body shop. he stripped them down and painted them

oh how I wish I could afford to do something like that, but my decals will have to work for now

love it.

yup its a ground. thanks

need some help. I have a Ti two fuse block. I have the power in and out and my volt gauge hooked up bit it does not turn one. it looks like there is a remote wire hook up or is that a ground? I looked on the online manuals but it shows a remote and ground on that one. I only have one hook up

very nice man. I could use your services in making some door panles for my car. I jsut dont have the skills yet.

looks good. the signs are going in the headliner?

DANG!

I think there are an updated version of the octane amps.

ok great thanks. I have done some glassing before but it was smaller stuff and I just used old t shirts

figured out how to get the 4 subs in the trunk. now where do you guys get your fleece from for glassing? how think is it?

ttocs wrote:sound bad, no.. But if you don't mount them down well they very well could be the last thing to go through your mind if you have a wreck.

I have a 2x4 structure made in the back of the car. bolted to the floor and rear deck

ok I have my air ride fully installed. problem is I now do not have room for four 10s in the trunk. now can I put two in the trunk in my boxes I have already and then the other two in where the back seat was? will it sound bad anything? back seat was removed for my amp rack and what not.

all great info. I'm still going to install it as I have never ran one before. see how it works out. also need something to help take up the space were the back seat was..lol

thats what I have

looks great man. should be a clean install when done. hope mine can look this good.

ya the power core will be on the far side of the car from were the rcas are ran. lasst question do I run both power and ground from the battery to the core or just power and then ground it to the body? I have taken the power core apart cleaned it and everything then put back together. I think its th...