its possible but of course not recommended by most if u want amp to be efficient and last u must have enough current feeding ur system were at full volume ur not dropping below more then 1 volt also u will need to have atleast 2 in space all around the amp with atleast one fan pushin and one fan pul...

the positive connect to each other and the negitaves connect to each other

sorry couldn't get the pictures up for better detail

3.Cleaning/Washing Circuit Boards: Note: Many people are concerned about washing circuit boards with water. As long as no power is applied to the amp when washing, the amplifier is dried relatively quickly and is thoroughly dry before power is again applied, it is unlikely to do any harm. Some ampli...

cause cap is expanding tricky ........... yea not sure if that's just the angle of picture but looks to me like u burnt the bottom of the board like a torch was used a 65 watt iron is plenty ht enough to remove them I use the weller 51 that's only 50 watts just clean board up with rubbing alchol and...

usally signs they are bad or are suspect ull see the foil on the tops and sides shinking showing the silver casing a way to see if there slightly leaking is to use a piece of white notebook paper and slide it under cap on all sides see if any liquid is coming out

if u plan to remove then add a shot of new solder then make sure ur solder gun is atleast 40 watt or better the hotter the better since ull spend less time on via u want to keep tip of solder gun on the middle when u see the solder moltn slowly work cap to one side then do same to other side little ...

just push down on the top plastic part I wouldn't take it off there a bitch to take off and put back on with out tearing the plastic on the sides if its bulging u will feel it most time the rail caps are fine the problem with the pg caps are the power supply filter caps

and water is a ingredient in every solvent or liquid that is man made no?

caps only discharge when u touch both leads toghther

I can understand ur logic and I understand ur lack of experience water is only bad for electronics if it has power applied of if u let water sit on it for a long period of time and if u shake the board to get most water off then use a blow dryer u will never have water left under componets or in bad...

WATER IS FINE I BEEN REPAIRING CAR AMPS FOR 4 YEARS NOW AND ITS ALOT FASTER THEN USING Q TIPS I LEARNED FROM PERRY BABIN LOOK HIM UP IF U NEVER HEARD OF HIM

hi to all next time u have a amp that is dirty like the pg titanuims that actualy pull dirt into amp instead of using alchol or acetone which I use to clean only when u have soot from burnt Parts just GIVE UR AMP A BATH YUP A BATH USE 409 CLEANER SPRAY DOWN AMP LET IT SIT FOR A MINUTE OR 2 TOPS THEN...

hi I know there are some great amp repair guys on site but I also repair amps and have a lot of knowledge on older good us made amps like pg, us amps , ppi and orion and currently not working so if any one needs a amp repaired I have the time and my prices are reasonable I am self taught with the he...

a idea I came up with is see if u can get a wall paper like the pg shrine has to use ase a backing instead of the basic carpet also was curious u still have the ms 1000 or know any one looking to sell one working or broken is good too ... brian

Hi Jay I admire ur building new mosfet board and hope to learn how to make one I was hoping u can help me I need to replace the thermoistor in the pgzxti475 but can not seem to find any info on it it has c299 printed on it can u help me out

looks like u put alot of time into it u have any picts of wut it looked like b4 ?

if they actually leaked then u can have more problems that could of been caused from caps leaking

yea make sure u did not put 1 in backwards ,all screws were put back in and are tight and all insulators are on correctly

hi u stell have amp for sale?