Guys, All your input is appreciated. But I think you can tell just by replies here its impossible to come to a consensus on what the finish should be to make everyone happy. For example, put a bunch of lights on the inside, then half the guys will say it looks like a flea market amp. The other half ...

Hurry up and finish that sucker!!!

Ahh the memories...

No problem. Your system power would be:

Front 4 ohms/2 ohms Stereo: 150w x 2 or 250w x 2
Rear 4 ohms bridged: 500w x 1
Sub 2 ohms: 900w x 1

Lots of power in a small package.

Rockcrawl,

We are in the final stages of testing 1600.5 now. Expect it shipping next month.

A very strong amplifier in a small package. They are doing about 150w x 4 at 4 ohms on front/rear and 900w plus on the channel at 2 ohms.

Sub channel is not stable to 1 ohm.

Guys please email me here: [email protected]

Sending a PM here isn't the best way to get ahold of me. Sometimes the notifications goes to junk mail or a go a few days without checking the site.

Email is best.

I bet that thing has a TON of head room. Very cool!!!

Elite.5 addresses the issue if someone wanted a smaller power Elite four channel and monoblock. It would also be smaller than two separate amplifiers. Elite amps are not small, but with smaller size come some compromises that we don't want to make. If you are looking for a small, really good soundin...

freshkryp69 wrote:Bring back a updated limited version of the ZPA amplifier! And make it indestructible!

We did its called the Elite series.

Lots of good info here guys, we are reading.

BTW: Elite.12d dual 2 ohm woofer is a done deal. Will ship in the 3rd quarter of this year.

Eric,

I will get some internal pics up shortly.

I am also putting together a white sheet now with details on electrical designs, stay tuned.

Just change the setting on the config switch see if the problem goes away, or wiggle the potentiometers one at a time.

I would not remove the switch or pots from the board, its very easy to damage traces unless you are used to repair work.

Its 90% likely it a bad config switch or potentiometer.

Congrats Rob! Well done.

1.5 ohms is a BAD idea. Stick to around 4 ohms or a little higher if possible.

We may add a dual 2 ohm. We shall see....

More rare than a Reactor.

I am always here to support!

Last year we had a large presence at Daytona/SBN with the Devastor, etc.

This year is much smaller, just has to do with timing and other factors.

Noted on the Apparel requests.

Very nice...

No problem. Will drive around 700w-800w RMS at 8 ohms.

Elite.5 makes around 400w RMS at 4 ohms for the subwoofer channel.

If you like the sound of your Xenon's you will love the Elite.

Short term we are focused on 5 channels, but we realize 6 channels are also becoming very popular/more application friendly in new cars.

Ti, Ti2 and Elite 5 channels all have subsonic filters. We even added variable phase on the sub section for Ti2 and Elite. Ti600.4, Ti800.4, and new Ti21000.4 also all have subsonic filters on the rear channels. SD, R and RX do not have subsonic on rear/sub channels due to either physical PCB space ...

Pics, we need some pics!

On the Ti2 10 inch woofer I specifically warned, "If you set the level properly and not go crazy on the volume knob you should be OK." With the level set wrong and/or listening at very high levels its very possible the sub will fail thermally, hence my warning. We don't preach "overpo...