cheers for the offer paintguy i will let you know

mike

cool tell me more just the leds that fail???

and theres no solder on the pads at all the other side is soldered in also no remnants on the legs so looks like it was missed from new!

yeah bvut imagine how much clarity and warmth that cap can bring to your sound lol!!!!!!!!!!!!!!!

yeah have to admit there a joke but it gives you some idea whats out there

i mean beeswax caps whats next lol!!

well pulled the board out the amp to gain access to the caps and to drill out the rounded bolt in the heat sink and guess what !! one of the thermal resistors dropped out the board its never been soldered in its just had the bolt holding it lol!! :shock: :shock: oh what does the sticker under the po...

ive been cap hunting too and found these guys
http://www.hificollective.co.uk/catalog/-c-61_68.html

well after buying this amp decided it need bringing back to how it should be

loved!!

so will be doing a lil resto thread on the amp and shroud

just started pulling it apart now!!

If your MS2250TA has shorter input caps, I highly doubt they need to be changed. The shorter ones are significantly newer, and should use better technology in their construction. The only real reason I can see for changing them is so they look better (taller ones seem to look better IMO). Increasin...

i have got a local perforated mesh stockist i am going to do it as it was when new so i will l be using steel and getting the whole shroud powder coated
although looking at the shrouds base it actually looks like it was stove enameled ?

cheers mate il get some ordered then

sorry to be a pain in the ass but whats the thickness of the perf also?

the perfs themselfs the mount holes im good with

right i need to replace the perf mesh on my shroud i dont have a original to copy

sooo i need to know the hole diameter and center to center of the holes so i can order some new meshing


anyone help???

yeah a layer of dynamat extreme then 1/2 inch of rockwool insulation i find works well

put me down for ms 2250 with shroud no 220594

thanks

mike

right il give it ago on some scrap and post up the results!!

i think you may run ito problems with the vehicle battery they only run a battery to power the base systems on the car start chucking high current demands at it and i think you will have problems they do not run a normal alternator system and use a dc to dc converter to charge the 12v battery this i...

im sure this was on the forum but cant seem to find it? the ti finish is sanded sheet steel thats clearcoated ? who has done the finish and got it close? i have a belt linisher 4 inch wide i need to do some small parts to match the install do you think thats possible so whats the best grit that gets...

nope they will be dash warning lamps etc just want to lay them out as per the tri led theme

tried emailing you but comes back as failed to send??

cool thanks !

hey folks im after making a led display for the dash in my car and i have 9 leds to light so i thought i could use the tri led pattern from the ti line so i want 3 sets of tri lights on a plate about head unit width and height then some cool phoenix ltd edition logo below so anyone have any good ide...

for gods sake dont connect the wires on the front they are not isolated from each other or that case and a small fire and melting plastic/ wires would ensue!!

they are just a show piece from a dealer display the tri leds light and thats it
i have 3 i assume you picked it up from talk audio then!!

that depends on what you are running(ie amp wise) but i always run 0 gauge to a dist unit the the car the split down to smaller gauge there

that way you can always add more to the system and not worry about wiring overloads etc

zbr100 i have one new in packaging will fit neg or poss and it has 2 1/0-4 gauge and two eight gauge

cant you swop out the deck for another one and retest see if it still has the same problem?