My new Phoenix Gold TI91, FAS and SFAS instalation. Updated

Post by **joerg** » Wed Aug 24, 2011 10:24 am

If u have enough time after u finished your awesome looking install i´ve got a BMW-525 Touring u could work on, until i´m back from Israel if u want too.

spiritofnorway · Post by **spiritofnorway** » Wed Aug 24, 2011 10:31 am

And the right side ...

spiritofnorway · Post by **spiritofnorway** » Wed Aug 24, 2011 10:33 am

joerg wrote:If u have enough time after u finished your awesome looking install i´ve got a BMW-525 Touring u could work on, until i´m back from Israel if u want too.

OK Joerg....

Until now there are 769 hours work

.. and it goes on it will show the pictures but I still have many on my camera ... format and must be brought only on the right ..

Post by **ttocs** » Wed Aug 24, 2011 1:26 pm

mounting looks good and clean but you realized the idea of the TLD's, is to mount them as close as possible to the music source to minimize noise that can be picked up, and now amplified by your TLD's and then the amp right? Putting them in back could be a significant introduction of noise into the stereo because any noise will be subj to the same gain the music is. If they were not up front, I would not run them personally. Mine are normally connected to the deck via a 12" cable(or less and mounted under the HU.

Post by **stipud** » Thu Aug 25, 2011 7:25 am

ttocs wrote:mounting looks good and clean but you realized the idea of the TLD's, is to mount them as close as possible to the music source to minimize noise that can be picked up, and now amplified by your TLD's and then the amp right? Putting them in back could be a significant introduction of noise into the stereo because any noise will be subj to the same gain the music is. If they were not up front, I would not run them personally. Mine are normally connected to the deck via a 12" cable(or less and mounted under the HU.

x2. It won't add a significant amount more noise (only the distortion caused by adding items to the signal chain), but you are defeating their purpose by having them in the rear of the car. In the front of the car they increase the signal strength so that noise inducted over the length of the RCA is less noticeable, but in the rear of the car it will amplify the noise just as much as it amplifies the signal, therefore defeating the point.

spiritofnorway · Post by **spiritofnorway** » Thu Aug 25, 2011 10:06 am

I was in the front part of the car really no place it is difficult to obstruct the HU ...
We have tried it and it detected no disturbing noises.
regards Geri
And it continues with the boot, I do not know what I want you all show I have so many photos and I'll add at the end of a link where you can view all photos.

Post by **ttocs** » Thu Aug 25, 2011 10:17 am

Breakin out the dowels, and I thought I was the only one... Looks good again, my only concern is the space under the amps looks a little light for cooling purposes, they get perty warm.

spiritofnorway · Post by **spiritofnorway** » Thu Aug 25, 2011 10:23 am

I've tested, and the amplifiers are cooled by two fans.
The temperature remains at 48 °C

spiritofnorway · Post by **spiritofnorway** » Thu Aug 25, 2011 11:42 am

Of course, the new home of the Cyclone is not forgotten

SilverGT · Post by **SilverGT** » Thu Aug 25, 2011 6:00 pm

love it so far. great work. some day I would love to hear one of them subs

thingy · Post by **thingy** » Fri Aug 26, 2011 7:44 am

subscribing and may i say : WOW

spiritofnorway · Post by **spiritofnorway** » Fri Aug 26, 2011 12:05 pm

Next I'll show you some pictures of the wiring.
Greet Geri

spiritofnorway · Post by **spiritofnorway** » Fri Aug 26, 2011 12:36 pm

There are a lot of photos wwwwww

66GTO-MS2125 · Post by **66GTO-MS2125** » Fri Aug 26, 2011 4:21 pm

an amazing install and my favorite part is the use of all the "classic" components. keep up the great work. wish i was close enough to hear and see the finished product.

spiritofnorway · Post by **spiritofnorway** » Tue Aug 30, 2011 11:00 am

Now comes the good part .....
It will be the amplifier.
Geri

spiritofnorway · Post by **spiritofnorway** » Tue Aug 30, 2011 11:42 am

And it continues with photos ...

spiritofnorway · Post by **spiritofnorway** » Tue Aug 30, 2011 12:08 pm

Photos Photos Photos ...

marko · Post by **marko** » Tue Aug 30, 2011 12:24 pm

very nice attention to detail without unnecessarily being OTT, my kinda install, well done indeed

spiritofnorway · Post by **spiritofnorway** » Thu Sep 01, 2011 10:59 am

Hello people
I come now to the last part of the installation.
is the headunit to turn on his amp connection of the Cyclone and the fine tuning with my dealer.
There is competition at the weekend, held in Vienna EMMA I will visit with my car, I hope to have a good feedback about installation and SQ.

It must still be some improvements made to put the tweeter as the Ti1 in the A-pillar and a bevel of the left midrange.
But first, the next pictures.
regards Geri

SilverGT · Post by **SilverGT** » Fri Sep 02, 2011 5:47 pm

great work on the wireing.

Mr. Wild · Post by **Mr. Wild** » Mon Sep 05, 2011 1:36 am

Unique stuff! I bet that slaps.

RayBuck · Post by **RayBuck** » Mon Sep 05, 2011 6:55 am

NICE!!! Who made the MS cap bank?

spiritofnorway · Post by **spiritofnorway** » Mon Sep 05, 2011 10:55 am

Hi guys
show you the next pictures.
I noticed on the weekend in EMMA competitions and have come to the 4th place in SQ just one point behind the third
I must still make improvements for the next application on 15 October.
Look at a lot of fun.
regards Geri

brett.b10 · Post by **brett.b10** » Mon Sep 05, 2011 1:16 pm

superb Geri RESPECT to you

Nils · Post by **Nils** » Fri Sep 16, 2011 8:17 am

Nice Install, this type of instal is what i like, i like builds that have been built with great pride

you have a good eye to small things that no one can see, and you carry out all the way. Really like your instal

My new Phoenix Gold TI91, FAS and SFAS instalation. Updated

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat

Re: My new Phoenix Gold Cyclone,TI951, FAS and SFAS instalat