new car old parts install
Posted: Fri Jan 03, 2014 10:54 pm
I have a lot of parts from my older vehicles. I just bought a new 2014 Honda Accord 4 dr and the system sucks. I am going to use the stock deck with a processor.
I only have room for front door speakers and tweeters and rear deck speakers. I want to keep my trunk room and fold down the rear seats if possible. Will buy a set of 6.5 focal componets.
I have laying around:
AMPS
1 PG ZX450
1 PG Xenon 4.200
1 Alpine mrf 540
1 Soundstream 300sx
SPEAKERS
Diamond Audio Hex 6.5 componets
2 Soundstream SPL 10's
1 Soundstream SPL 12
Is the Zx450 a better amp than the Xenon 4.200
the Apine 540 seems to small at 50 watts @12v and 80 watts @ 14.4 birth sheet says 83 watts
Should I sell all the parts and start new or will some of these old parts do the job.
i want it loud and clear. dont know about clipping and ohms just want to best for the money
I only have room for front door speakers and tweeters and rear deck speakers. I want to keep my trunk room and fold down the rear seats if possible. Will buy a set of 6.5 focal componets.
I have laying around:
AMPS
1 PG ZX450
1 PG Xenon 4.200
1 Alpine mrf 540
1 Soundstream 300sx
SPEAKERS
Diamond Audio Hex 6.5 componets
2 Soundstream SPL 10's
1 Soundstream SPL 12
Is the Zx450 a better amp than the Xenon 4.200
the Apine 540 seems to small at 50 watts @12v and 80 watts @ 14.4 birth sheet says 83 watts
Should I sell all the parts and start new or will some of these old parts do the job.
i want it loud and clear. dont know about clipping and ohms just want to best for the money