fiberglass help
- Thunderdome
- Posts: 806
- Joined: Mon Feb 09, 2009 4:19 pm
- Location: Ont.
fiberglass help
hey guy,s hoping someone here can help me I need to do a lot of fiberglass work in the rear area of my rx-7 on the bare metal pretty much the whole rear hatch area and was wondering what is the best thing to spread out so the fiberglass doesnt stick to the metal---is masking tape ok? as I have a free supply or will the resin burn through? any insight would be greatly appreciated thanks
-
-
-
Remember: The chart serves only as a starting point. Ultimately you must use your ears as a guide.
-
-
Remember: The chart serves only as a starting point. Ultimately you must use your ears as a guide.
Masking tape will be fine. Multiple layers of tape is better than one as resin can seep between the seams of a single layer.
Give it a liberal coating of PAM or a coating of carnuba wax to act as a mold release before you lay any resin or mat down.
Give it a liberal coating of PAM or a coating of carnuba wax to act as a mold release before you lay any resin or mat down.
M25 x 2, M50, M44, M100, Original MS 275, MS2125 & MS2250 (with shroud), XMax 15, White EQ215X, EQ232, PLD1,BLT, MX3, AX-406A, Basscubes, + Soundstream, Earthquake, RF, Boston, OZ Audio & KEF
- knightrider358
- Posts: 1318
- Joined: Mon May 04, 2009 3:37 am
- Location: Virginia, Near D.C.
Yea man masking tape will be fine. also When I do glassing I had an installer a loooonngggg time ago show me that when u actually mix bondo and glass together. 2 parts of glass to 1 part bondo its allot easier to work with and its not as how would I say harsh on other materials. But It does work great when finishing it off.
Current 1 of 2 current installs
HU-Alpine IVA-D310
DSP-PXA-H701
Comps-JL ZR 650
Sub-3 JL 10w6v1ae's sealed
Highs amp-MS275
Mids amp-MS2125
Subs amp-MS2250TA
HU-Alpine IVA-D310
DSP-PXA-H701
Comps-JL ZR 650
Sub-3 JL 10w6v1ae's sealed
Highs amp-MS275
Mids amp-MS2125
Subs amp-MS2250TA
- Thunderdome
- Posts: 806
- Joined: Mon Feb 09, 2009 4:19 pm
- Location: Ont.
I was going to recomend the aluminum foil as well. I normally put down a layer of tape first, then cover that with foil. This way it should just pop right out and will pull the foil with it. As mentioned above it will be dificult to get it all out but it will not hurt anything.
I would recomend putting down a sound dampin layer before you have done any of what was mentioned. Second skin is what I recomend.
I would recomend putting down a sound dampin layer before you have done any of what was mentioned. Second skin is what I recomend.