Has anyone successfully refinsihed Ti Series amp shrouds?

Need help with your car stereo system? Have a technical question? Post here.
Post Reply
cmo27
Posts: 3
Joined: Fri Jan 15, 2016 2:40 am

Has anyone successfully refinsihed Ti Series amp shrouds?

Post by cmo27 »

I have several Ti series amps, while many of them are in fantastic condition, I have 2 that I'd like to try and remove the few rust spots on. Has anyone successfully accomplished this? If so, what methods did you use? Thanks in advance!
ttocs
the Floor Sweeping Hack with Golden Ears
Posts: 14783
Joined: Fri Dec 19, 2008 9:53 pm

Re: Has anyone successfully refinsihed Ti Series amp shrouds

Post by ttocs »

yes its not too hard. All the finish is, is a brushed metal surface with a flat clear powder on it. I can't remember the grain of sandpaper I used but I think it was around 220 grit. Sand down through the clear, through the rust in the same direction as the brushed grain on the amp. When your done just put some clear on it and if you look close you will see a difference but its better then seeing the rust from 20 ft away.
what else can I say I am a grumpy asshole most of the time.
cmo27
Posts: 3
Joined: Fri Jan 15, 2016 2:40 am

Re: Has anyone successfully refinsihed Ti Series amp shrouds

Post by cmo27 »

Perfect. Thanks for the info.
Post Reply