Need help with your car stereo system? Have a technical question? Post here.
eyesofra
Posts: 613 Joined: Wed Feb 28, 2007 11:41 pm
Location: from Cameron Highlands MY to ACT AU
Contact:
Post
by eyesofra » Sun Apr 01, 2007 4:11 am
some help needed again frens,
i read thru errin's write-up on gain setting with DMM.
IT's been of great help.
i've been adjusting my gains with the x-over and ssf filters enabled.
Is this correct or do i have to bypass the filters, adjust the gain ,then enable and get to the crossovers ?
pls help. Thanks again
stipud
Voltage Ohms
Posts: 14719 Joined: Sat Nov 26, 1983 4:00 am
Location: Burnaby, BC
Contact:
Post
by stipud » Sun Apr 01, 2007 6:02 am
If your SSF is below, and the LPF is above the frequency you tested it at (50 to 60Hz), then you will be fine. I think the SSF is set at 25, and you probably had your LPF well above 60 as well, so you should be good
eyesofra
Posts: 613 Joined: Wed Feb 28, 2007 11:41 pm
Location: from Cameron Highlands MY to ACT AU
Contact:
Post
by eyesofra » Sun Apr 01, 2007 6:57 am
thanks stipud,
set my SSF around 25Hz and LPF at 70, guess i'm ok then.