Phoenix Gold Phorum

Guys here have been asking for some pics/systems with the new gear so I thought I would pass this along. Its only one pic for now, but you can tell this thing is gonna be crazy....

Comes from our dist in the Philippines, it has 16 Ti10's and countless mids at this point. More pics to follow...

"HOLY-SHIT" ...That's Craaaaaazy.

certainly looks loud

Say goodbye to the doors hinges thats an awful lot of tweeter,I'm sure it's loud but I wonder how it sounds???

hi guys!

here's a follow up of what morgan posted. we hope to build more PG cars (extreme and normal) in the following months.

PG "Green Bastard"
Car: Toyota Bb
Gears:
Pioneer P99RS
16 pcs Ti10d4 (in clamshell ported box)
4 pcs R110 (as midbass)
16 pcs Ti65cs
4 Ti2500.1 for the subs
7 Ti600.4 for mids and tweeters
6 Stinger SPV70 batteries
Tons of wires!
Tons of work!


our PG Philippines facebook page:

http://www.facebook.com/pages/Phoenix-G ... 2362204898

Crazy shit...

Maybe I should consider doing that to my highlander too...

Insane!!!! More pics enjoy!

ah, where are the seats? Did they put a lowering kit on it or is it just the added weight of the system that makes it ride low now? Man I see that I can only imagine how much time their shop newb spent sanding that thing.....

Over the top for sure.

Great show install to show off all the new gear, but i hate those fridges on wheels.

The seats are invisible? Nifty.

@ttocs
the suspension was replaced with a TEIN coil over kit. the rears were slightly modified to make it stiffer due to the heavy load of the system.

6 batteries were located under the front seats to distribute the weight. but the amps are just as heavy!

@thumper
naah, the seats in front are still intact. the last picture from Morgan was prior to putting them back on. but the door handles are invisible!

@everyone
will try to post pics of the VIP Nissan if i find the pics. that install is a little more subtle with the following PG gears:
Ti2500
Ti800.4
2 x Ti10d4

Pictures of the installation PLEASE
Regards Geri

I would argue that there wasn't anything hidden under the seats since they are missing in the one pic....

ttocs wrote:I would argue that there wasn't anything hidden under the seats since they are missing in the one pic....

"Look chief, I'm not here to argue sublantics."

it sure is in your face..

but i'm personally not a fan unfortunately... it sure will get the PG Ti's out there, thats for sure!

I'd roll that booger......
I'll bet it's REALLY loud.........

Any numbers posted on this install?

ttocs wrote:I would argue that there wasn't anything hidden under the seats since they are missing in the one pic....

My head is kinda spinning on that as well, not only are they not there now I don't see how they could fit under the seats anyway. There is batteries there but how much did you have to lift seats there can't be that much room under them.

who needs seats when you need extra batteries! If you stacked 2-3 of them on their sides, you could make a bench seat of of them...

nobody travels to their nearest state run Aquarium to see minnows.
tourists typically wanna see the whale sharks and the big stuff.
most of us here on the phorum are more like marine biologists than tourists (if you will allow that analogy)
that's why we all wanna see something we understand. something we can relate to, something SQL!


what is posted in the pics above is not directly aligned with my personal tastes, but...
i understand why shops build such demo vehicles - we all understand that, right?

with that being said i would give a left nut to have all that gear.
afterall, i have more amps in boxes and on shelves than i have installed. many of us do.

i like my original Ti gear, not just because it sounds good, but also because it looks good and ya
can't buy it at the local shop these days. i take pride in owning and maintaining "old shit." It brings back memories
of a time i will never have again...unless im rockin some nasty funk at about 140dB
blah blah blah