Page 1 of 1
Old lpl on new elite amps?
Posted: Fri Jan 02, 2015 5:10 pm
by Weaklink
Wondering if anyone has tried it. Replacing my reactor with an elite.5 and like the location and look of my old lpl. Don't really need the LEDs on the elite knob. Thanks for the help.
Re: Old lpl on new elite amps?
Posted: Fri Jan 02, 2015 5:14 pm
by todd217
I think Morgan said they were different
Re: Old lpl on new elite amps?
Posted: Fri Jan 02, 2015 5:58 pm
by trickyricky
DON'T DO IT!!!
They are not the same...one member here was kind enough to send me his elite remote so I can make extras if needed, let me know. If you already have one then you just swap them out (the cord as well).
Re: Old lpl on new elite amps?
Posted: Fri Jan 02, 2015 6:35 pm
by Weaklink
Ok. I'll swap them then. It would be nice if the remote flush mounted better like the lpl.
Re: Old lpl on new elite amps?
Posted: Fri Jan 02, 2015 8:41 pm
by trickyricky
Did you remove the whole casing? I believe you can mount it behind a trim panel if you have enough room (I think it was about 1.5" in depth on the pcb).
Re: Old lpl on new elite amps?
Posted: Fri Jan 02, 2015 10:09 pm
by Weaklink
I think I do. I just need to track down a nut for it. The shaft floats in the case.
Re: Old lpl on new elite amps?
Posted: Mon Jan 05, 2015 1:28 am
by MW3
It won't work properly, do not use old LPL with Elite amplifiers.
Elite circuit is much improved and much quieter than LPL.
So is the new RBC circuit used in all the other new amps.