PG MS2250 inline fuse for power
PG MS2250 inline fuse for power
when I decide to install what amp should the inline fuse be at for this amp?
Last edited by gqtrebor on Sun Sep 18, 2016 2:13 am, edited 1 time in total.
-
- Posts: 593
- Joined: Fri May 13, 2011 12:03 am
Re: PG MS2250 inline fuse for paower
the oem ms2250 has two internal fuses of 50A each.
personally i would (and will do when i install them myself) i would go to a big ANL fuse of
150A on a 2 gauge OFC (not CCA !!!) B+ and B- wire.....
certainly if you use it as sub amp....
for speakers, maybe it will be enough with 4 gauge and a 100A fuse if you play at 4ohm stereo for SQ....
i would certainly put a deep cycle battery in the back.....
personally i would (and will do when i install them myself) i would go to a big ANL fuse of
150A on a 2 gauge OFC (not CCA !!!) B+ and B- wire.....
certainly if you use it as sub amp....
for speakers, maybe it will be enough with 4 gauge and a 100A fuse if you play at 4ohm stereo for SQ....
i would certainly put a deep cycle battery in the back.....
Re: PG MS2250 inline fuse for paower
it depends on how you are going to use it. The MS was designed to be driven at low ohm loads but when you drop it down it can suck the amps up. I would not recomend putting the largest fuse you can, its better to use the smallest fuse you can to protect things if something goes wrong. How manu subs, what ohm load is the amp going to be driven at?
what else can I say I am a grumpy asshole most of the time.
Re: PG MS2250 inline fuse for paower
4 ohm stereo going to only be running two JL 10's
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Last edited by gqtrebor on Sun Sep 18, 2016 2:14 am, edited 1 time in total.
-
- Posts: 1653
- Joined: Sun May 06, 2012 8:01 am
Re: PG MS2250 inline fuse for paower
Then a 60-80amp should be plenty.
Re: PG MS2250 inline fuse for paower
trickyricky wrote:Then a 60-80amp should be plenty.
Cool thanks.