Page 1 of 1
PG MS2250 inline fuse for power
Posted: Sat Sep 17, 2016 9:06 am
by gqtrebor
when I decide to install what amp should the inline fuse be at for this amp?
Re: PG MS2250 inline fuse for paower
Posted: Sat Sep 17, 2016 11:09 am
by zeropoint0.5
the oem ms2250 has two internal fuses of 50A each.
personally i would (and will do when i install them myself) i would go to a big ANL fuse of
150A on a 2 gauge OFC (not CCA !!!) B+ and B- wire.....
certainly if you use it as sub amp....
for speakers, maybe it will be enough with 4 gauge and a 100A fuse if you play at 4ohm stereo for SQ....
i would certainly put a deep cycle battery in the back.....
Re: PG MS2250 inline fuse for paower
Posted: Sat Sep 17, 2016 12:20 pm
by ttocs
it depends on how you are going to use it. The MS was designed to be driven at low ohm loads but when you drop it down it can suck the amps up. I would not recomend putting the largest fuse you can, its better to use the smallest fuse you can to protect things if something goes wrong. How manu subs, what ohm load is the amp going to be driven at?
Re: PG MS2250 inline fuse for paower
Posted: Sat Sep 17, 2016 12:21 pm
by gqtrebor
4 ohm stereo going to only be running two JL 10's
Sent from my iPhone using Tapatalk
Re: PG MS2250 inline fuse for paower
Posted: Sat Sep 17, 2016 4:59 pm
by trickyricky
Then a 60-80amp should be plenty.
Re: PG MS2250 inline fuse for paower
Posted: Sun Sep 18, 2016 2:14 am
by gqtrebor
trickyricky wrote:Then a 60-80amp should be plenty.
Cool thanks.