|
It is currently Thu Feb 21, 2019 9:10 pm
|
View unanswered posts | View active topics
 |
|
 |
|
Author |
Message |
Eric D
|
Post subject: I need help with a tweeter  Posted: Sun Jun 04, 2017 12:15 pm |
Short Bus Driver |
 |
Joined: Sat Dec 30, 2006 8:50 am Posts: 4233
|
I need to find a replacement Rockford Fosgate tweeter from many moons ago...
FNQ 1401 or FNQ 2401
If you have any or know of any, please let me know. I have one that failed on me, and I don't wish to replace the whole component set unless I have no choice.
_________________ Got "schooled" by member shawn k on May 10th, 2011... No longer really "in tune" with the audio industry, and probably have not been for some time. Hands down the forum's most ignorant member... Don't even know what Ohm's law is...
|
|
|
|
 |
Bchester6
|
Post subject: Re: I need help with a tweeter  Posted: Mon Jun 12, 2017 6:04 am |
Joined: Wed Dec 15, 2010 10:14 pm Posts: 336 Location: Oside, Ca.
|
|
|
|
 |
Eric D
|
Post subject: Re: I need help with a tweeter  Posted: Mon Jun 12, 2017 8:50 am |
Short Bus Driver |
 |
Joined: Sat Dec 30, 2006 8:50 am Posts: 4233
|
Bchester6 wrote: I don't have much experience with those comps but I can tell you that there are a few used sets on Ebay right now. This one may have the tweets your looking for but comes with mid bass drivers as well. http://www.ebay.com/itm/A-pair-of-used- ... ch&vxp=mtrI could not find any sets with tweeters on eBay. The set you have the link too actually have MB Quart tweeters in the photos, not Rockford ones. I have a feeling these are going to be too rare to find.
_________________ Got "schooled" by member shawn k on May 10th, 2011... No longer really "in tune" with the audio industry, and probably have not been for some time. Hands down the forum's most ignorant member... Don't even know what Ohm's law is...
|
|
|
|
 |
ttocs
|
Post subject: Re: I need help with a tweeter  Posted: Mon Jun 12, 2017 5:14 pm |
the Floor Sweeping Hack with Golden Ears |
Joined: Fri Dec 19, 2008 9:53 pm Posts: 14423
|
have you tried the rockford fanatics page on fb?
_________________ what else can I say I am a grumpy asshole most of the time.
|
|
|
|
 |
itchnertamatoa
|
Post subject: Re: I need help with a tweeter  Posted: Mon Jun 12, 2017 11:14 pm |
Joined: Sat Dec 23, 2006 1:15 am Posts: 2295 Location: TAHITI
|
which set has them Eric? I have a FNQ comp set .. but don't have it with me here in Tahiti .. nor do I have pics of it .. but could have Jason look up if it's the correct set
_________________
|
|
|
|
 |
Eric D
|
Post subject: Re: I need help with a tweeter  Posted: Tue Jun 13, 2017 2:15 am |
Short Bus Driver |
 |
Joined: Sat Dec 30, 2006 8:50 am Posts: 4233
|
I don't have a Facebook account.
I dug around last night looking for something unrelated and I came across 2 FNQ prototype tweeters I had. I am going to try them out and see if they will work.
_________________ Got "schooled" by member shawn k on May 10th, 2011... No longer really "in tune" with the audio industry, and probably have not been for some time. Hands down the forum's most ignorant member... Don't even know what Ohm's law is...
|
|
|
|
 |
Bchester6
|
Post subject: Re: I need help with a tweeter  Posted: Wed Jun 14, 2017 7:36 am |
Joined: Wed Dec 15, 2010 10:14 pm Posts: 336 Location: Oside, Ca.
|
Yes this may be a hard find.. hopefully the protos work out or you may have to mix it up with something that has similar characteristics. I have some old MTX Thunder Pros that are a nice soft dome in the garage if you need them. Good luck Eric.
|
|
|
|
 |
ttocs
|
Post subject: Re: I need help with a tweeter  Posted: Wed Jun 14, 2017 9:08 am |
the Floor Sweeping Hack with Golden Ears |
Joined: Fri Dec 19, 2008 9:53 pm Posts: 14423
|
Eric D wrote: I don't have a Facebook account.
I dug around last night looking for something unrelated and I came across 2 FNQ prototype tweeters I had. I am going to try them out and see if they will work. I just made a post there for you. I will let you know what turns up.
_________________ what else can I say I am a grumpy asshole most of the time.
|
|
|
|
 |
Eric D
|
Post subject: Re: I need help with a tweeter  Posted: Wed Jun 14, 2017 11:13 am |
Short Bus Driver |
 |
Joined: Sat Dec 30, 2006 8:50 am Posts: 4233
|
I have to stick with originals as they mount co-axially with the midrange on the speaker grill.
Normally I would be OK with changing them to something more modern.
_________________ Got "schooled" by member shawn k on May 10th, 2011... No longer really "in tune" with the audio industry, and probably have not been for some time. Hands down the forum's most ignorant member... Don't even know what Ohm's law is...
|
|
|
|
 |
itchnertamatoa
|
Post subject: Re: I need help with a tweeter  Posted: Wed Jun 14, 2017 8:35 pm |
Joined: Sat Dec 23, 2006 1:15 am Posts: 2295 Location: TAHITI
|
Eric D wrote: I have to stick with originals as they mount co-axially with the midrange on the speaker grill.
Normally I would be OK with changing them to something more modern. that's the set I have ... all I remember was that the tweeter was mounted in the middle of the grill
_________________
|
|
|
|
 |
Bchester6
|
Post subject: Re: I need help with a tweeter  Posted: Fri Jun 16, 2017 4:58 am |
Joined: Wed Dec 15, 2010 10:14 pm Posts: 336 Location: Oside, Ca.
|
|
|
|
 |
Eric D
|
Post subject: Re: I need help with a tweeter  Posted: Fri Jun 16, 2017 8:15 am |
Short Bus Driver |
 |
Joined: Sat Dec 30, 2006 8:50 am Posts: 4233
|
That is close to correct, but is the bottom of the line P series not the top of the line Q series.
Mylar domes in the P vs aluminum in the Q. Also, the Q tweeters handle more power I believe, but I don't know how, as they have the same motor structure in all three lines, P, X, and Q.
_________________ Got "schooled" by member shawn k on May 10th, 2011... No longer really "in tune" with the audio industry, and probably have not been for some time. Hands down the forum's most ignorant member... Don't even know what Ohm's law is...
|
|
|
|
 |
|
|
 |
|
 |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|