Has anyone successfully refinsihed Ti Series amp shrouds?
Has anyone successfully refinsihed Ti Series amp shrouds?
I have several Ti series amps, while many of them are in fantastic condition, I have 2 that I'd like to try and remove the few rust spots on. Has anyone successfully accomplished this? If so, what methods did you use? Thanks in advance!
Re: Has anyone successfully refinsihed Ti Series amp shrouds
yes its not too hard. All the finish is, is a brushed metal surface with a flat clear powder on it. I can't remember the grain of sandpaper I used but I think it was around 220 grit. Sand down through the clear, through the rust in the same direction as the brushed grain on the amp. When your done just put some clear on it and if you look close you will see a difference but its better then seeing the rust from 20 ft away.
what else can I say I am a grumpy asshole most of the time.
Re: Has anyone successfully refinsihed Ti Series amp shrouds
Perfect. Thanks for the info.