100.4 or 200.2 ?

gentlejax2 · Post by **gentlejax2** » Thu Apr 10, 2008 2:55 pm

is one any better than the other? I would run the 100.4 bridged of course...but is there any advantage of one or the other as far as build?

Post by **Bfowler** » Thu Apr 10, 2008 2:58 pm

nope. the 200.2 is a bit smaller....

if you ever wanted to bridge it, the 200.2 would give you more power into 1 channel...

thats about all i can think of

gentlejax2 · Post by **gentlejax2** » Thu Apr 10, 2008 3:09 pm

would a 200.2 like a 6ohm load? I guess so ....I just wonder what it would put out due to the xe load....?

I guess I havnt researched the xe load....but I got some 6ohm Orion XTR mids I want to try.....but I havnt figured out how I am going to due that...

I mean to say I will need to figure out the crossover situation or just run it right off the amp if possible...

I am going to run a set of mids off a 200.2

Post by **Francious70** » Thu Apr 10, 2008 4:22 pm

A 200.2 with 6 ohms would put out around 150x2. A 100.4 bridged with 6 ohms will put out 200x2.

Thank you XeLoad.

gentlejax2 · Post by **gentlejax2** » Thu Apr 10, 2008 4:32 pm

is that true? I might have to get one of each...

Post by **Bfowler** » Fri Apr 11, 2008 8:13 am

yep^ because each channel on the 100.4 will do 100 watts from 1-4 ohms, a 6ohm bridged load is the same as 3ohms on each channel (stereo)

so the 100.4 will do 200 x 2 up to 8ohms

dejo · Post by **dejo** » Fri Apr 11, 2008 2:37 pm

I was stupid and got rid of one of my 100.4 and cant trade back for it because it will make 8 ohm power and my buddy wont come off it.