Phoenix Gold Phorum

Hi I am very interested in this amp, but there is not a lor of info out there, does anybody already received this amp??
Any comment, opinion or PIC about it?

THANKS!!

Here are some specs on the amp.

Ti2 1600.5 SPECIFICATIONS
FRONT AND REAR CHANNELS:
Frequency Response: ± 1dB from 20Hz to 20kHz
Signal to Noise Ratio: >100dB
Crossover Slopes: 12dB per Octave
Front High Pass Crossover Range: 20Hz to 4kHz
Rear High Pass Crossover Range: 20Hz to 4kHz
Rear Low Pass Crossover Range: 40Hz to 4kHz
Low Level Input Range: 200 millivolts to 8 volts
Lowest Recommend Load: 4 ohms Bridged/2 ohms Stereo
Typical Efficiency: 80%
Damping Factor Greater than 200
RMS Power Output 125w x 4 @ 4 ohms Stereo
200w x 4 @ 2 ohms Stereo
400w x 2 @ 4 ohms Bridged


SUBWOOFER CHANNEL:
Frequency Response: ± 1dB from 20Hz to 300Hz
Signal to Noise Ratio: >100dB
Crossover Slopes: 12dB per Octave
Low Pass Crossover Range: 20Hz to 300Hz
Subsonic Crossover Range: 10Hz to 50Hz
Variable Phase: 0 to 180 degrees
Low Level Input Range: 200 millivolts to 8 volts
Lowest Recommend Load: 2 ohms
Typical Efficiency: 80%
Damping Factor: Greater than 200
RMS Power Output 500w x 1 @ 4 ohms
800w x 1 @ 2 ohms
Recommend Power Wire Fuse: 100a
Power/Ground Wire Size: 4 Gauge
Dimensions: 14.4” L x 7.1” W x 2.0” H
366mm L x 180mm W x 52mm H

Available yet?

Should be in 1-2 weeks.

maybe now? does anybody saw a review on this amp?

thanks!

bump

I just ordered one of these amps and will soon be writing my review and how it handles everything.
equipment installed as followed:
04 MUSTANG COBRA TERMINATOR
SONY XA-601BT HEAD UNIT
TI21600.5 PHOENIX GOLD
Morel Maximo 6.5 component speakers in the front
PHOENIX GOLD TI57 IN THE REAR
2 12" TI212D4 or ti212d2 IN THE REAR

rhino555 wrote:I just ordered one of these amps and will soon be writing my review and how it handles everything.
equipment installed as followed:
04 MUSTANG COBRA TERMINATOR
SONY XA-601BT HEAD UNIT
TI21600.5 PHOENIX GOLD
Morel Maximo 6.5 component speakers in the front
PHOENIX GOLD TI57 IN THE REAR
2 12" TI212D4 or ti212d2 IN THE REAR

Good, I am interested in your opinion, I was very close to get this amp for myself but because some circumstances I end with a very different equipment.

great amp to have, small package, great output :

149 x 4= 4 ohm , 542 X 1 = 4 ohm
224 X 4 = 2 ohm , 922 x 1 = 2 ohm

So I got my amp installed yesterday and got the birth certificate on it also, pushing 145watts @ 4ohms per channel to the front and 910 bridged at 2ohms stable to the subs. So far very good and sounds great. Instead of putting the 2 ti212d4 subs right now I got a nice pair of JLW3 AT 4OHMS PER AND BRIDGED THEM. THE AMP REALLY HANDLES EVERYTHING EXTREMELY WELL. Those Morel components in the front that I put in sound awesome and clear as a summer day with no pollution to be seen for miles,and the 5x7 Phoenix Gold in the rear really handle the power well and sound great. Very happy with looks and the compact size of the amp. I'll take some pics and hopefully be able to attach them to show you guys. the pics are to large to attach.

rialtoss wrote:great amp to have, small package, great output :

149 x 4= 4 ohm , 542 X 1 = 4 ohm
224 X 4 = 2 ohm , 922 x 1 = 2 ohm

Forget the fact that the Elite.5 is 1 ohm stable and the Ti isn't for a moment. The 149x4 @ 4 ohm and 922x1 @ 2 ohm is more power than the Elite.5 at the same load. I tend to think that would end up being the most commonly run load on a 5 channel amp, and that is impressive numbers.

rhino555 wrote:So I got my amp installed yesterday and got the birth certificate on it also, pushing 145watts @ 4ohms per channel to the front and 910 bridged at 2ohms stable to the subs. So far very good and sounds great. Instead of putting the 2 ti212d4 subs right now I got a nice pair of JLW3 AT 4OHMS PER AND BRIDGED THEM. THE AMP REALLY HANDLES EVERYTHING EXTREMELY WELL. Those Morel components in the front that I put in sound awesome and clear as a summer day with no pollution to be seen for miles,and the 5x7 Phoenix Gold in the rear really handle the power well and sound great. Very happy with looks and the compact size of the amp. I'll take some pics and hopefully be able to attach them to show you guys. the pics are to large to attach.

Thanks for come here again to share your comments, do you have an install thread? or a specific review thread for the amp? If not you really should do it, there are almost no info in the web about this amps..we all know the specs, but at least in my opinion is nice to see photos of real installations and comments of the owners

do you have an install thread? or a specific review thread for the amp? PLEASE EXPLAIN THIS. I'M NOT REALLY SURE WHAT YOUR ASKING. I DON'T UNDERSTAND THAT TERMINOLOGY. PLEASE EXPLAIN AND I WILL DO MY BEST AT AN EXPLINATION