It is currently Sun Jun 24, 2018 5:48 pm

All times are UTC - 8 hours




 Page 1 of 1 [ 3 posts ] 
Author Message
 Post subject: Has anyone successfully refinsihed Ti Series amp shrouds?
PostPosted: Thu May 24, 2018 3:45 am 

Joined: Fri Jan 15, 2016 2:40 am
Posts: 2
I have several Ti series amps, while many of them are in fantastic condition, I have 2 that I'd like to try and remove the few rust spots on. Has anyone successfully accomplished this? If so, what methods did you use? Thanks in advance!


Offline
 Profile  
 
 Post subject: Re: Has anyone successfully refinsihed Ti Series amp shrouds
PostPosted: Thu May 24, 2018 4:14 am 
the Floor Sweeping Hack with Golden Ears

Joined: Fri Dec 19, 2008 9:53 pm
Posts: 14318
yes its not too hard. All the finish is, is a brushed metal surface with a flat clear powder on it. I can't remember the grain of sandpaper I used but I think it was around 220 grit. Sand down through the clear, through the rust in the same direction as the brushed grain on the amp. When your done just put some clear on it and if you look close you will see a difference but its better then seeing the rust from 20 ft away.



_________________
what else can I say I am a grumpy asshole most of the time.
Online
 Profile  
 
 Post subject: Re: Has anyone successfully refinsihed Ti Series amp shrouds
PostPosted: Fri May 25, 2018 5:16 pm 

Joined: Fri Jan 15, 2016 2:40 am
Posts: 2
Perfect. Thanks for the info.


Offline
 Profile  
 
Display posts from previous:  Sort by  
 Page 1 of 1 [ 3 posts ] 

All times are UTC - 8 hours


Who is online

Users browsing this forum: Google [Bot] and 9 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to: