Remember to check how deep the speaker can be, I have a E39 and upgraded to speakers from Bavsound. I couldn`t have to deep speakers so remember to measure the depth of the speaker hole before bying anything.

Merry Christmas

That is my experience too, distortion kill subwoofers, clean power dosen`t.

Jacampb2 you are absolute right, these are 2 HP DPS-1200FB in parallell. These can be adjusted to 12.5V ish but they are capable of compansate up to 1.5V.
So these are modified with a resistor fooling the psu to compensate +1.5V so that the output is 13.6V ish.

Now i have the Psu connected to 2 MS275 bridged 4ohm, one on each frontspeaker in a 5.1 setup. It runs very well and i can hardly hear the fans between songs, like Jacampb2 said its whisper quiet. This is a recommended solution with a lot of amperes for the money. My plan is a total of 5 Ms/Mps amps...

A little test setup. I will pick up the third ms275 at the post office tomorrow and then all 3 of them is going for recap. The Mps2500 has done the recap. Havent bought the fifth amp yet but will do soon. Not sure if its gonna be a 2125 og 275. Have a recapped 2125 by hand. My setup by now is a Deno...

Thanks for the info guys, i will check how the parallell connection is done. The seller told that the fan is very noisy at high load like 80-90% but hi claimed it was very quiet at low and middel load because it was Temperature and load-dependent. I guess i must hear myself but if its very noisy at ...

Hi again, It showed up that the Audioauthority was discounted so i ended up with a guy selling modified server Psu`s. The spec was 13.5V/100A. He could also connect 2 of them together either into 27V/100A or 13.5V/200A. He said they were professional modified to operate in parallell. Not sure what t...

Thanks for your reply guys, i will have a look at Ebay and see what i can find. The Power supply i linked to i my first post is a little suspect i think, its called Hop Wo and the 2x80A its when operating in 25V. At 30V its push out 67A but at 12v i couldn`t find out, it just says 2000w? Suspect tha...

Hi, i`m planning to use some old PG MS amps for my home theather and looking for power supply. Found one claiming to put out 2x80A. It can adjust output voltage 12vdc-30vdc but it can also adjust output current for manual charging of lead-acid batteries. Can this be used for amps? Can i just set the...

I thought the ms2125 and the mps2500 is the same power but the mps2500 needs lower impedance to deliever max. The Dyno of the ms2125 i believe maxed out 1194w dynamic.
The ms2250 has twice the power and maxed out 2409w dynamic.

Yes i agree, never to much power. Will try both 1200.1 Thanx for your replies

The aesthetics and even the space is not really that important because the amp(s) will be hanging hidden on the backside of the Sub box. Current draw is a factor yes, my car has a 150A alternator and a 100AH battery so the current availability is not that bad. But i wonder what is the ultimate power...

Hi Guys, I`m up with some new subs in my car and have bought 2 Ground Zero GZRW30SPL EXTREME 1400W. These have a power handling of 1400W spl and 800-900w RMS. These are dual 2 ohms. In my museum i have 3 Exile amps, one X24001. and two x1200.1. So the question is if i should use one x1200.1 on each ...

Thanks for the answer. Sad to hear that Brian/Exile dont keep their promises. Will check out the memphis or pac rca remotes.

Bjornar

Hi!
I have 2 Exile x1200.1 amps i am planning to install in my car to push one 12" Ground Zero each. These Amps are Remote bass level/boost compatible but i dont have these remotes. Does anyone know where to buy these or if i coulduse anything like the LPL44 or similar?

Thanx
Bjornar

Anyway.. next summer i will have to buy a new car so i guess i will have to buy one with room for 12"`s or 15"`s :D So Bjørnar.... Time to pick up this thread again. The Volvo is gone, and the BMW is finally in your posession... What's it gonna be, 12" or 15"s ?? :wink: My dream...

Wow, the 4-way TS2080... I cannot remember that you had such speakers installed? I guess that was a couple of years before I got the honor of becoming a friend with you... :wink: I had one pair of those aswell a small period, back in the red BMW. They were blown to pieces, and I replaced them with ...

Those were the days :) My first "high end" player was the Pioneer FX-K5 cassette deck with a separate FM-tuner. Fantastic radio recieving from very far away but not very good sound quality as far as i can remember. But it didnt matter, i was king of the road, i guess it was back in 90-91 a...

Done. Good luck

Yes that sure is a AD12. Its a really great sub. Celestion is an old brand, they make great speakers for home use and for guitar players. Dont think you will find much on the internet from they`re car audio period because it was just a short time. They made 2 series of subwoofers, the pro serie name...

Hi there! Yes it was the AD12 i had in my car when writing this thread. I`m not quite sure but i think the specs on the AD12 is 300W continius and 600W max. I used a Phoenix Gold MS275 2ohm mono on my 2*AD12 so that gave them 150-180W each. Later i used the ZX450 and that should give them 250-300W e...

I new cars i think they put some kind of 12V source in the cigarette lighter hole while changing the batteries to unvoid any problems with the car losing the current. I guess its enough with a small 12V batteri or you can use a small "start helper"

According the the manual the 275 is stable to 2 ohms mono. Any one done it and know the power output? MS275 Stable into Bridged Mono 2ohm loads, 1 LR Stereo MPS2240: Stable into Bridged Mono 1 ohm loads, 1/2ohm Stereo I think i remind that the user manual says that the MS275 goes into overload when...

Pedi wrote:I do NOT want a Volvo

Yeah right that's what they all say