I had the same problem with my Ti600.2 only a week ago.

Hadn't used it for about 18months and when my installer connected a sub to it the sub would pound with no music playing.

Mine ended up being the amps cross over pot.

Hi guy's.

I own a bass cube and for some reason when my original install came out the front metal plate which the controls attach to has gone missing.

Are these available as a spare part as I need a replacement.

Happened to me to when switching between presets. After discussions with PG and the Australian distributor at the time mine was replaced with an EQ30 and a credit for the difference in price. They also replaced the tweeter at no cost. PG did ofer to fix the DEQ with the firmware upgrade however i ch...

The 9's sound pretty good as they are right now. Im sure though they would sound even better in a sealed enclosure. When I have people listen to the system I always have the sub off first. I have one of the memory settings with the sub off and the 9's rolling off naturally. So just the 3 way playing...

Actually the boot is very usable. I can still fit about 8 cartons beer in there. The top picture is with the panels in place hiding all the gear. The Ti1200.1 power's the Ti12d. I'm using one Ti1000.2 per side to power the Elite 5 and tweeter in the kick's through the passive cross over and the othe...

It's been a while but here is my install as it sits today. A lot of the components from my previous install "Ti EQ30, Ti 15 powercore, Ti bass cube and the Optima battery" have not been used as i wanted to save as much weight as possible. Also the panels were made from marine ply as it is ...

stipud wrote:

E350Titanium wrote:Ti9's with 250 watts per channel is what you need. Simple really.

Hey, welcome back!

Maka, this guy has a kick ass install almost identical to your own.

Thanks stipud.

It's been very busy in the land down under.

Ti9's with 250 watts per channel is what you need. Simple really.

No problem i'm not on my computer at the moment but when i get on mine i'll post them up.

Thanks B

So around the 627 watts is about it then.

Still plenty though. It bumped nice for me when i was using it.

The birthsheet of my Ti600.2 states 627 watts bridged into 4 ohms but i would like to know what the rough wattage would be into bridged 2 ohm. I'm trying to sell this amp to a guy who wants need to run a single 12" sub at 2 ohms. I did run 2 10" 4 ohm subs into bridged 2 ohms without any p...

Thanks gents

Just the answers i was hoping for.

Im going to put my Elite 9-5-1 and 12d system back in my old car. :D It will be powered by 2 Ti1000.2's and a Ti1200.1. What if i was to wire the Elite 5-1 comps (with supplied cross over) to the right channel of each Ti1000.2 and then the left channel of each amp to the 9's. Therefore having one Ti...

Here was mine

Firstly i want to say F**K i miss my old set up. :cry: Does any one use or have heard the Elite 6 comps with an Elite 12d. Im thinking of using this set up but im a little worried that the 6 and sub will not blend as well and not get that up front bass that i had in my old Elite 9-5-1 and 12d set up.