what to write?

Post by **ttocs** » Sat Jun 20, 2009 6:50 pm

I have been working on the cover to go around my DD5 that I mounted in the passenger airbag location to cover the wiring. During this time I realized that the back of the cover could be made into a neat little backlit display with out too much trouble. The area is approx 8" x 6" and I can't figure out what would look cool. I am running a LE octane and plan to paint the DD5 to match when I am done with this project and I have considered the octane logo or a pg logo of some type or even a miniture lay-out of my system. I have also considered mounting a remote voltage display which would take a few square inches up. What would you write?

reallyxxxxxxloud · Post by **reallyxxxxxxloud** » Sat Jun 20, 2009 7:57 pm

Enough said

knightrider358 · Post by **knightrider358** » Sun Jun 21, 2009 4:01 am

I concure ^

Post by **ttocs** » Sun Jun 21, 2009 3:35 pm

I had not looked at my cardomain page for a while. I knew that I had done some work that I needed to update on there but didn't realize how far I had fallen behind. I updated it today to show the new projects I have completed and even some pics of the outside....... These two covers are the last parts of the system until I upgrade the deck.

Who had that program to make the neat little system diagrams with pics?

http://www.cardomain.com/ride/3237206

dBincognito · Post by **dBincognito** » Sun Jun 21, 2009 3:47 pm

ttocs wrote:I had not looked at my cardomain page for a while. I knew that I had done some work that I needed to update on there but didn't realize how far I had fallen behind. I updated it today to show the new projects I have completed and even some pics of the outside....... These two covers are the last parts of the system until I upgrade the deck.

Who had that program to make the neat little system diagrams with pics?

http://www.cardomain.com/ride/3237206

Eric posted that....some free program from Microsoft IIRC....should be able to get it from their site

Found Eric's post

http://office.microsoft.com/en-us/visio/default.aspx

Post by **ttocs** » Sun Jun 21, 2009 9:11 pm

I tried that program and idunno if I am doin it wrong but it has me ready to throw my laptop. I can't do anything on the page after opening the program......