See if you can guess what I'm doing now....

Zomb1fied · Post by **Zomb1fied** » Fri Jan 18, 2008 3:12 pm

It has something to do with this shit -

And this would be the completed back end that is hardening...

dedlyjedly · Post by **dedlyjedly** » Fri Jan 18, 2008 3:15 pm

looks like you're going to be waiting a long time for that to harden! Are those puddles of resin?

Post by **fuzzysnuggleduck** » Fri Jan 18, 2008 3:19 pm

Door pods?

Zomb1fied · Post by **Zomb1fied** » Fri Jan 18, 2008 3:49 pm

dedlyjedly wrote:looks like you're going to be waiting a long time for that to harden! Are those puddles of resin?

it's already hard

putting your hand close to it is kinda like a radiator

Post by **Bfowler** » Fri Jan 18, 2008 4:03 pm

bodykits?

Post by **stipud** » Fri Jan 18, 2008 4:15 pm

Small sub box?

Post by **Bfowler** » Fri Jan 18, 2008 4:17 pm

supercharger?

Post by **mr tibbs** » Fri Jan 18, 2008 5:27 pm

Kitty litter box?

Post by **stipud** » Fri Jan 18, 2008 5:32 pm

Bfowler wrote:supercharger?

Ultracharger?

dedlyjedly · Post by **dedlyjedly** » Fri Jan 18, 2008 5:41 pm

skub?

one_lo_one · Post by **one_lo_one** » Fri Jan 18, 2008 5:52 pm

Looks like the back of a Nissan 240 SX hatch rear passenger side panel and your building a subenclosure to fit there.

Zomb1fied · Post by **Zomb1fied** » Fri Jan 18, 2008 6:45 pm

one_lo_one wrote:Looks like the back of a Nissan 240 SX hatch rear passenger side panel and your building a subenclosure to fit there.

Close ! it's the rear thinger out of a 318ti and I'm attempting to build a woofer enclosure

Zomb1fied · Post by **Zomb1fied** » Fri Jan 18, 2008 6:46 pm

stipud wrote:
Bfowler wrote:supercharger?
Ultracharger?

funny you should mention that as it goes.

I had the bearings milled in the other day and had it running on plastic gears spinning on the bearings.

The plastic gears lasted about two minutes before melting but as soon as I get the proper impellor shaft machined it's going to work