ttocs wrote:I have used sticky tape for alot of router projects. Use the 3m stuff and you will need to be carefull how much you put down for fear of not getting them apart.
If you ever run into this bud, just use a good heat gun and blast some hot air in between the gap for a few seconds. Then carefully use your pry tool and they should come apart like easy peasy
HOLY INSTALL!! Batman you gots to see this clean aZZ system.
DAMN!!!!
Dude Got Skills.
Attachments
robin.jpg (14.16 KiB) Viewed 7590 times
(1) Pioneer avh-p4300 dvd
(1) eDnine.2 a/b_
(2) eDnine.1 Class D
(1) TI BassCube
(2) Street Wires distro block [power/ground]
(6) JL AUDIO 15w0v2's
http://mobile.jlaudio.com/products_subs_pages.php?page_id=278
ttocs wrote:they look good and yet I think maybe some paint on them would make them pop a little more.
They are made from brushed aluminum. Pics, as usual, don't do it justice. The ring is textured black and the spokes are aluminum. Done this way to flow with the amps as well as the oem aluminim rims. Paint would look out of place IMO
Used to write for CSR years ago
