Stryker's 96 T-Bird 3k daily
Stryker's 96 T-Bird 3k daily
Well it's about time to get started on this fairly large change over for me.
I've asked myself a few times why, and without a doubt it's to have more POWER!!!! Nothing wrong with the old setup, sounded great, was loud hit hard etc etc, but it hadn't changed in 5 years. To start with I'm going with 2-1200.1Rsd's, 1-500.4 Rsd, 215ix, BASS CUBE, 35 farad stinger cap and upgrading to 0/1 gauge wire and matching rca's(colorwise) lol. Having 3 kids and so on i had to cut corners on a few things, such as RCA's. cause i would have like blue far better but these were practically given to me. I've ran the snot out of the 400ZXTi at 2OHM's and well we all know how they like to draw current. so i'm gonna run 4OHM's now and see what it's like. new subs are around the corner just not yet.
please feel free to add comments and give opinions and advice. I've had alot of setups through the years but this is by far the most power. def. looking forward to it. i'll try to keep the pic's flowin and i'm hoping this does not take more than a week or two. here's the pic's of the tearout.
I've asked myself a few times why, and without a doubt it's to have more POWER!!!! Nothing wrong with the old setup, sounded great, was loud hit hard etc etc, but it hadn't changed in 5 years. To start with I'm going with 2-1200.1Rsd's, 1-500.4 Rsd, 215ix, BASS CUBE, 35 farad stinger cap and upgrading to 0/1 gauge wire and matching rca's(colorwise) lol. Having 3 kids and so on i had to cut corners on a few things, such as RCA's. cause i would have like blue far better but these were practically given to me. I've ran the snot out of the 400ZXTi at 2OHM's and well we all know how they like to draw current. so i'm gonna run 4OHM's now and see what it's like. new subs are around the corner just not yet.
please feel free to add comments and give opinions and advice. I've had alot of setups through the years but this is by far the most power. def. looking forward to it. i'll try to keep the pic's flowin and i'm hoping this does not take more than a week or two. here's the pic's of the tearout.
Last edited by Stryker on Tue Mar 15, 2011 4:59 pm, edited 17 times in total.
screw car audio, I'd rather go fast....errr, wait a minute.
try again they were all backwards lol.
- Attachments
-
- the subject
- DSC01736.JPG (377.12 KiB) Viewed 26386 times
-
- looking far too crowded. gonna try the trunk floor look tomorrow.
- DSCN2705.JPG (433.12 KiB) Viewed 26509 times
-
- dam these are big amps. guess my measurements were a shade off.
- DSCN2704.JPG (435.07 KiB) Viewed 26509 times
-
- The palate, was hoping to use this over with new carpet but i don't think it's gonna work out.
- DSCN2703.JPG (411.58 KiB) Viewed 26509 times
-
- nice and tidy;) what you can't see don't worry about.
- DSCN2701.JPG (394.08 KiB) Viewed 26509 times
-
- wow that was cleansing
- DSCN2700.JPG (446.51 KiB) Viewed 26509 times
-
- the final disconnection
- DSCN2699.JPG (426.65 KiB) Viewed 26509 times
-
- thx to kg1961 i finally got this started. gave him back the 600ZXTi in a trade. soooo now's the start.
- DSCN2698.JPG (409.3 KiB) Viewed 26509 times
-
- Oh the memory's. but hey look what i'm movin too!!
- DSC05210.JPG (351.43 KiB) Viewed 26509 times
Last edited by Stryker on Mon May 18, 2009 6:54 pm, edited 1 time in total.
screw car audio, I'd rather go fast....errr, wait a minute.
Ok after ripping most of the interior out I should be good to go with the deadening of the car. It's real quiet already so I'm not gonna go too crazy jus a few spots that i know about. Weather is gonna be shat here for a couple of days so I'm gonna do up the amp rack. hopefully someone comes through with a black EQ for me. I don't really need it but it makes it look far more symmetrical with 2 and I'm a straight lines kinda guy.
The stinger cap is gonna be hidden behind the rack and I'm going to cut some holes that are hidden underneath the 1200.1's. this cap lights up the whole room and has some ridiculously bright led's inside of it that shine through the blue plexi. admittedly it just does not match the PG gear so it's goin be hiding. I did manage to come up with an arrangement for all this gear with the help of my middle daughter Annika. I can even use the same carpet and the holes are usable and hidden.....bonus. As you can see the 230EQ just looks dumb but i do like how it fills out the rack better than the crossover's. we shall see what happens with the trade offer for it. Here's a few pic's of the layout I'm gonna use and i still can access the spare and have some trunk left for whatever. I do like this setup as i can access all the amp controls and so on. till later.
The stinger cap is gonna be hidden behind the rack and I'm going to cut some holes that are hidden underneath the 1200.1's. this cap lights up the whole room and has some ridiculously bright led's inside of it that shine through the blue plexi. admittedly it just does not match the PG gear so it's goin be hiding. I did manage to come up with an arrangement for all this gear with the help of my middle daughter Annika. I can even use the same carpet and the holes are usable and hidden.....bonus. As you can see the 230EQ just looks dumb but i do like how it fills out the rack better than the crossover's. we shall see what happens with the trade offer for it. Here's a few pic's of the layout I'm gonna use and i still can access the spare and have some trunk left for whatever. I do like this setup as i can access all the amp controls and so on. till later.
- Attachments
-
- DSCN2717.JPG (447.23 KiB) Viewed 26459 times
-
- DSCN2718.JPG (441.32 KiB) Viewed 26459 times
-
- DSCN2720.JPG (405.82 KiB) Viewed 26459 times
screw car audio, I'd rather go fast....errr, wait a minute.
I have 2 options too work with at the moment: option #1 is Clarion 15's dual 2OHM VC's. I will run each at 4OHM not 1 OHM. i know everyone may be saying HUH??? Well I bought these in a package deal with the capacitor. Dude had them since 2006 and they were sitting in a disco van not being used, save for the one summer van was on the road . They are virtually new and certainly not broke in because they seemed to get louder by the day when i had them hooked up to the 600ZXTi @ 2OHM's. they do have some thump. for 150CAD for 3 i'm not worried if they last or not, plus I have an extra in case. option#2 The tried and true RF punch HE 15's, had these in my car and a previous vehicle since 2000. I like them but they are only rated 200RMS, 400 max, so I'm thinking they may be toast fairly fast with somewhere around 750-800 rms from the new PG's. I would prefer to keep these in V.good condition as I'm building an old skool rockford system on the side. I have only listened to the Clarions for a few weeks and they do hit alot harder than my RF's so they will be my first choice. I do not have loads of listening time under my belt on a variety of subs so I do not know whats what so to say. I have plans for 4-12inch Rsd's in the near future so i can run the 1200's at 2OHM's As it sits I would like to have A DVD deck and center channel before new subs.steelbath wrote:Nice! What subs will you be pushing with the 1200.1's?
As far as another black EQ, This is a slam dunk as kg1961 has come through for me once again. He's gonna go grab his black 215x outta storage and then I'm going to get it from him on Weds.
here's the pic's of the sub choices,let me know if you think Clarion or RF. keep in mind the RF's are low power subs that matched well with the 600ZXTI but were only seeing approx 300 watts RMS each.
I had also forgotten to mention that I'm using AVI 5.25BSM comps in kicks on the floor in front, 5.25 Clif Designs comps front doors and in the back. Eclipse 5415 deck ,it's older but has the 5V pre outs. soon be be DVD anyway.
till next time.....
later
- Attachments
-
- DSCN2725.JPG (301.02 KiB) Viewed 26384 times
-
- DSCN2724.JPG (367.31 KiB) Viewed 26384 times
-
- DSCN2723.JPG (338.16 KiB) Viewed 26384 times
-
- DSCN2722a.JPG (346.43 KiB) Viewed 26384 times
-
- DSCN2721a.JPG (374.94 KiB) Viewed 26384 times
screw car audio, I'd rather go fast....errr, wait a minute.
- oldskoolmseriesfan
- Sherlock Homey
- Posts: 2517
- Joined: Sun Oct 19, 2008 10:03 pm
- Location: WEST SIIIIDE!!
- Bfowler
- Briaans..... BRIAAAAANNNNNNS
- Posts: 10766
- Joined: Wed Dec 06, 2006 11:06 am
- Location: So easy, a cavewomen could do him
from a power, reliability standpoint. NOoldskoolmseriesfan wrote:correct me if I am wrong, isnt the RSD line quite a significant downgrade from the ZX line?
from a crossover and processing features point. YES
the
my ex-girlfriend said "its car audio or me"
i've had tougher choices at a soda machine...
i've had tougher choices at a soda machine...
- oldskoolmseriesfan
- Sherlock Homey
- Posts: 2517
- Joined: Sun Oct 19, 2008 10:03 pm
- Location: WEST SIIIIDE!!
same or better power then? and not quite the SQ?Bfowler wrote:from a power, reliability standpoint. NOoldskoolmseriesfan wrote:correct me if I am wrong, isnt the RSD line quite a significant downgrade from the ZX line?
from a crossover and processing features point. YES
the
Phorum PI!
Square woofers are GAY!!
Square woofers are GAY!!
- mr tibbs
- Forum Goatee
- Posts: 3895
- Joined: Sun Dec 17, 2006 3:03 pm
- Location: The land of morons, I mean mormons.:(
Brain freeze??Bfowler wrote:from a power, reliability standpoint. NOoldskoolmseriesfan wrote:correct me if I am wrong, isnt the RSD line quite a significant downgrade from the ZX line?
from a crossover and processing features point. YES
the
[url=http://www.usbr.gov//][img]http://www.usbr.gov/images/banner-3.jpg[/img][/url]
I loved the Clarions I had MANY years ago. I'd go w/the Clarions too, but then again I despise RF and love Clarion as much as WE love PG
"ZPA's will have the same sound essentially as you get from the MS, they just feature a bigger shinier set of balls."
Install:
http://phoenixphorum.com/viewtopic.php?f=10&t=16998
Install:
http://phoenixphorum.com/viewtopic.php?f=10&t=16998
- dBincognito
- Randy Bo-Bandy
- Posts: 3301
- Joined: Fri Feb 06, 2009 11:32 pm
- Bfowler
- Briaans..... BRIAAAAANNNNNNS
- Posts: 10766
- Joined: Wed Dec 06, 2006 11:06 am
- Location: So easy, a cavewomen could do him
i would not agree with that.
failure rates went down after they moved off shore.
i think the beginnning of the end was when they started building gear with the mindset "will this make money?" instead of the mindset "will this be bad ass?"
which just happened to be around the same time. just my observation
failure rates went down after they moved off shore.
i think the beginnning of the end was when they started building gear with the mindset "will this make money?" instead of the mindset "will this be bad ass?"
which just happened to be around the same time. just my observation
my ex-girlfriend said "its car audio or me"
i've had tougher choices at a soda machine...
i've had tougher choices at a soda machine...
- dBincognito
- Randy Bo-Bandy
- Posts: 3301
- Joined: Fri Feb 06, 2009 11:32 pm
Bfowler
I think they had to conform with the flood of cheap amps on the market....and of course all the marketing gimmicks and people not knowing what's what.....they were just trying to stay in business.....I don't think you can really blame them for that....if they had kept building amps here in the US, I'm sure their profit margin would have dropped quite marginally. Everybody moved overseas.....it almost seems inevitable now days
Stryker
Sorry for invading your thread....everything is looking good
I think they had to conform with the flood of cheap amps on the market....and of course all the marketing gimmicks and people not knowing what's what.....they were just trying to stay in business.....I don't think you can really blame them for that....if they had kept building amps here in the US, I'm sure their profit margin would have dropped quite marginally. Everybody moved overseas.....it almost seems inevitable now days
Stryker
Sorry for invading your thread....everything is looking good
Wonderful setup, you`re gonna love your RSD amps, they are really good amps. I have a RSD 1200.1 and a RSD500.4 and they are great. I took out 2*ZX450v2 and replaced them with the 2 RSD amps, the 500.4 sounded the same as a ZX450 (at least i cant hear any different) but the RSD1200.1 is a real powerhouse pushing out approx 1400 watts. Looking forward to se it all mounted in your car.