Phoenix Gold Phorum

Made and broke the mold for one side...do the other tomorrow. Took about 2 hours to get three solid coats down and dry enough to pop it off the door. Turned out ok considering I didn't even pull the panel to do it. Just built it up till it held the upper portion where gravity works against it while drying.

More pics of the other side tomorrow....

I would be suprised if they had completely cured in that time. I like to leave my molds in overnight to ensure they have completely cured and that they are not going to warp anymore and I live in the desert where everything dries fast. They only have to flex a little to not fit worth a crap again....

Looks great bogart! You guys have so much confidence doing this stuff, guess mine will get better once I get going. Good work.

glass is easy...it was still hot when I pulled it....I couldn't leave it in the car more then I did. It is a daily runner.

The cast is huge...realistically, I am using about 1/3 of that for the backing. If it flex's a wee bit it is ok...I generally use chopped bondo to seat it again once it is cut and then start the face.

Chris...ready for me sometime next weeek!? hehe...Missing some of my Ti 9 action!

Steve, what the hell my friend....it has been a few!!!! I've always got time for ya....would be nice to get that center and stuff started while the weather is ok for it.

I've got to go take a test on campus on tuesday at 1 o clock...other then that my week is pretty clear. May have to go back and talk to a counselor later in the week but I am not sure....wedensday sounds like a plan to me

Cool...I'll plan to stop by on Wednesday! Ya sorry for the last couple weeks..been busy...w/ the house/yard and crap like that...