What 10 inch sub do you recommend to match this setup ?
Posted: Sat Nov 28, 2009 3:45 pm
Going into the Forester using the factory location of teh stock 6x9 in the rear 1/4 panel. Will be sealed as best as is possible. Currently I have a CDT 8 inch in there and I'm less than impressed with bass response. It sounds like a 6 inch mid and when the power is turned up it distorts rather easily.
It will be powered by the rear channels bridged of a ZX450. I know the amp is working properly as when I swap in a box with dual IDQ 10's its plenty loud powering them in stereo.
Wondering if a single RSD 10 would give me what I want. Doesn't need to be super loud , just decent bass output when required. There should be at least .5 cubic inches of space in there.
It will be powered by the rear channels bridged of a ZX450. I know the amp is working properly as when I swap in a box with dual IDQ 10's its plenty loud powering them in stereo.
Wondering if a single RSD 10 would give me what I want. Doesn't need to be super loud , just decent bass output when required. There should be at least .5 cubic inches of space in there.