Phoenix Gold Phorum

Looks like shit. So many things went wrong this weekend working on it. I've got a few ideas I'm going to try over the next few weeks to make it look better. If it doesn't, than a new amprack I will build again. The wife knewI wasn't happy w/it. She could tell. Need to find better body filler, and not so thick terminals for the cap. It's not hooked up, just there for cosmetics. Trim pieces are in order now to clean up the edges. 1 Week at a time. Next week will be the box for the newly traded TREO SI12.22 sub. Right now I'm using "the box" w/the PG XMAX 10 in it. ALL of the room under the seat is now reserved for the sub. I mounted the Dyn Xovers on the side wall beside the rear bench seat.

Dyn Xover pass. side

Dyn Xover Driv. side

The best shot of the entire amprack I can get. Should've taken a pic when the seat was out.

Cap/distro


More to come when I build the box.

Wait a tick, am I mistaken or is that a Stinger distro block with a PG sticker over it??

mr tibbs wrote:Wait a tick, am I mistaken or is that a Stinger distro block with a PG sticker over it??

Edit:

Wait a tick, am I mistaken or is that Streetwires distro block with a PG sticker over it???

Streetwires it is. A friend of mine owns a decal shop, so I had him make it for me. He had to hand draw the PG logo then scan it. Copied it off of the ZPA plpexi.