Page 1 of 1
See if you can guess what I'm doing now....
Posted: Fri Jan 18, 2008 3:12 pm
by Zomb1fied
It has something to do with this shit -
And this would be the completed back end that is hardening...
Posted: Fri Jan 18, 2008 3:15 pm
by dedlyjedly
looks like you're going to be waiting a long time for that to harden! Are those puddles of resin?
Posted: Fri Jan 18, 2008 3:19 pm
by fuzzysnuggleduck
Door pods?
Posted: Fri Jan 18, 2008 3:49 pm
by Zomb1fied
dedlyjedly wrote:looks like you're going to be waiting a long time for that to harden! Are those puddles of resin?
it's already hard
putting your hand close to it is kinda like a radiator
Posted: Fri Jan 18, 2008 4:03 pm
by Bfowler
bodykits?
Posted: Fri Jan 18, 2008 4:15 pm
by stipud
Small sub box?
Posted: Fri Jan 18, 2008 4:17 pm
by Bfowler
supercharger?
Posted: Fri Jan 18, 2008 5:27 pm
by mr tibbs
Kitty litter box?
Posted: Fri Jan 18, 2008 5:32 pm
by stipud
Bfowler wrote:supercharger?
Ultracharger?
Posted: Fri Jan 18, 2008 5:41 pm
by dedlyjedly
skub?
Posted: Fri Jan 18, 2008 5:52 pm
by one_lo_one
Looks like the back of a Nissan 240 SX hatch rear passenger side panel and your building a subenclosure to fit there.
Posted: Fri Jan 18, 2008 6:45 pm
by Zomb1fied
one_lo_one wrote:Looks like the back of a Nissan 240 SX hatch rear passenger side panel and your building a subenclosure to fit there.
Close ! it's the rear thinger out of a 318ti and I'm
attempting to build a woofer enclosure
Posted: Fri Jan 18, 2008 6:46 pm
by Zomb1fied
stipud wrote:Bfowler wrote:supercharger?
Ultracharger?
funny you should mention that as it goes.
I had the bearings milled in the other day and had it running on plastic gears spinning on the bearings.
The plastic gears lasted about two minutes before melting but as soon as I get the proper impellor shaft machined it's going to work
