Page 1 of 1
My install is almost done, finally!
Posted: Sun Aug 24, 2008 9:48 am
by flogger11
Here are the pics of my final install, we ran out of carpet for my second generation box! (on order) Nope, I didnt do it all on my own, enlisted the help of a couple friends this weekend.
Posted: Sun Aug 24, 2008 1:28 pm
by lashlee
Yummy ZPA!! Why didn't you put the line driver up front where it belongs?
Posted: Sun Aug 24, 2008 1:32 pm
by phoenixcat
that's a nice install! i love the 0.5, i'm running it in my house and sounds goooooooooooooddddd !
i want your trunk, you got too much space
Posted: Sun Aug 24, 2008 1:43 pm
by buckster
Nice and clean
Posted: Sun Aug 24, 2008 2:13 pm
by flogger11
lashlee wrote:Yummy ZPA!! Why didn't you put the line driver up front where it belongs?
I already have nearly 4 volts at the amps (ty DMM) and have limited underdash space (hd radio receiver and sirrius still have to go in there in the long run), so screw it, I put the line driver in back. No biggy because of the 4 volts from my deck, if I wouldnt have had the full 4 volts in back, I would have gone the extra distance to put it under my dash.
Posted: Sun Aug 24, 2008 2:16 pm
by flogger11
I just noticed I didnt mount my ZX straight, arrrrg!
Posted: Sun Aug 24, 2008 3:28 pm
by seandiguer
How many subs? 2 or 3 there?
Posted: Sun Aug 24, 2008 3:40 pm
by flogger11
2 subs
Posted: Tue Sep 02, 2008 5:55 pm
by thedeal7235
ive never had line drivers near the h/u( via- no space)
Posted: Tue Sep 02, 2008 9:34 pm
by deathcloud
1) So Im confused on how you did your PLD-1 Install... Where and how did you get power and neg to it. Im about to do an install of a TLD-66 and need as much info as possible.
2) why on your ZX450 is your Output have RCAs to it? Where does that run to?
I wish I could do active set up with a 4 chan PG amp but the only hard part is getting to run speaker wire from the tweets all the way to the back... its a bitch.