Phoenix Gold Phorum

So, I'm getting this Viper 800ESP alarm system from Tom. Seems "full featured" and all.

I was wondering if there are any general or specific install tips you guys might have for me from your own experience doing alarm installs?

As some of you know, it's for a 1991 4Runner (two thread in this pseudo-empty forum, woo!) and everything else so far with this vehicle has been pretty straight forward so I'm hoping the same with this install in terms of working in the dash and with the electronics.

So is there really anything useful that can be said about this or do I just have read the install manual and tackle each small step along the way since each install can be different or have different factors?

12volts white - white/red + ignition harness

Starter black + ignition harness

Ignition _ black/yellow _ + _ ignition harness

Power Lock _ blue/white _ - _ door control relay
Notes: Door control relay is located behind the drivers dash speaker.

Power Unlock _ blue/yellow _ - _ door control relay
Notes: Door control relay is located behind the drivers dash speaker.

Parking Lights+ _ green _ drivers kick panel
Notes: Can also be found at any illuminated switches, radio, or some cigarette lighters.

Door Trigger _ black/white or black _ - _2 pin plug top fusebox

Trunk/Hatch Pin _ green/white _ - _ rear window relay
Notes: The rear power window relay is in the left rear quarter panel, behind trim, near tail light. The trunk pin can also be found yellow/black in the drivers kick (rest at ground, diode Isolate from dash indicator).

^whats funny/awseome is he remebers most of all that!

the other day i called him up and asked him if he knew which were the signal wires going to the factory amp from the HU of a 2000 crysler 300m.



he did....

I knew you would know.

Thanks man, you rocksor

One of these guides can be really helpful as well.....................

here is the techsoft printout if it helps anymore than what the other guy put.