Elite 9m as a midrange driver.

masonsjeep · Post by **masonsjeep** » Mon Apr 06, 2009 9:52 am

Is it possible to use the 9m driver as a midrange in a 2 way system using the TI Elite crossover.

The spec sheet on the 9m says a frequency response of between 40hz - 15khz.

Any ideas.??

Post by **stipud** » Mon Apr 06, 2009 9:55 am

If it sounded good, PG would have done it already. I found the 9M's weren't great above 1kHz. I guess you can try experimenting... but I doubt it will sound good, especially with the factory crossover.

masonsjeep · Post by **masonsjeep** » Mon Apr 06, 2009 10:01 am

Bigger plans for the doors may be needed then. Marko also said not above 1 khz.

So unless anyone has tried it back to plan A.

Post by **AVICJR** » Mon Apr 06, 2009 10:18 am

You could try the Morel factory xover, if they are close to the 9" mid and tweet component set they sell together then one of these may work.

http://www.morelhifi.com/products/mob_a ... cross.html

masonsjeep · Post by **masonsjeep** » Mon Apr 06, 2009 11:02 am

I have been told to stop being a pu**y and put the full set in. Oh well here goes nothing, now where did i put that jigsaw.

gkitching · Post by **gkitching** » Mon Apr 06, 2009 3:42 pm

That's the spirit!

Now go hack something up