pg xenon 600.1 or not?

sciullo779 · Post by **sciullo779** » Thu Nov 26, 2009 7:47 pm

ok i have 2, 10" 4ohm single voice coil subs rated fro 300wrms a piece, i have em in parallel for 600wrms@2ohm, my questions is should i buy the xenon 600.1 or will it kill them? or is that amp junk like im starting to read?

Post by **Eric D** » Thu Nov 26, 2009 8:32 pm

I would try an RsD amp over the Xenon. But then again, I am often the guy starting the "Xenons suck" threads.

Post by **Bfowler** » Thu Nov 26, 2009 8:41 pm

i like the xenons a lot still. but for your situation, i also think a rsd 600.1 is a better bet. the 2ohm load will make it make the most power.

NewOldStock · Post by **NewOldStock** » Thu Nov 26, 2009 10:20 pm

Eric D wrote:I would try an RsD amp over the Xenon. But then again, I am often the guy starting the "Xenons suck" threads.

deathcloud · Post by **deathcloud** » Fri Nov 27, 2009 4:46 pm

rsd 600.1 is a solid amp. No problems at all. And the footprint is small too. I liked it when I had it. I wish I still did

Post by **VW337** » Fri Nov 27, 2009 6:17 pm

the X600.1 is the most under-rated of the Xenon line many will actually give you in the 800W range.

The RSd is a solid bet as well and may be easier to locate.