Help with install

Rob221 · Post by **Rob221** » Wed Dec 30, 2009 10:42 am

Hello guys!A few weeks ago I asked for help installing a TLD22 and got good help (see my post Help with TLD22 install).So for Xmas I got a V8001.Was wondering how to put this all together and make it right.Do I still install the TDL22 as stated in my last post?Or do I install the LPL in to the V8001.Also on the X200.4 there is a 2 ch 4 ch button where should I have this set?If someone could walk me through how is the best way to set this all up it would be greatly appreciated have an Alpine 9856,X 200.4 and a V8001,CDT components in the doors and 2 RSdC102 subs in the rear.

Post by **kg1961** » Wed Dec 30, 2009 5:43 pm

use the lpl for the sub so if you going to use the v800.1 for subs use it there
let us know what you are using for high and lows
i would use the line driver to the 200.4 use 2channel setting for highs

audiophyle_247 · Post by **audiophyle_247** » Wed Dec 30, 2009 6:12 pm

This could get confusing, but here goes.

Connect the Alpine's front RCA outputs to the TDL22, then the TDL22 output to the X200.4 front input, set the 2ch/4ch selector to 2ch, then run the output from the X200.4 to the V800.1, plug the lpl into the V800.1 lpl port & walla.

That is probably the best way to hook up what ya have & get the most out of everything.

Rob221 · Post by **Rob221** » Wed Dec 30, 2009 6:40 pm

Thanks again audiophyle_247.Not confusing at all.What would be the best way to wire subs to V8001?

audiophyle_247 · Post by **audiophyle_247** » Thu Dec 31, 2009 10:04 am

Depends on the voice coil configuration.

Check out www.the12volt.com
You can find wiring diagrams to show you how to wire them.

Rob221 · Post by **Rob221** » Thu Dec 31, 2009 11:24 am

Ok i have 2 RSDC102's.So would this be the best way to hook them up to the V8001?

Help with install

Help with install

item