Titanium amps question

yeddy · Post by **yeddy** » Wed Apr 21, 2010 1:22 pm

So I just got my hands on a few Ti amps a 500.4, 600.2 and a 1200.1 from the bay... Now something common in all three amps is the main rail caps are swollen. Obviously I need to replace them all, is this really common? there is no other obvious damage anywhere else on the amps, is there anything else that should be replaced?

Misfire · Post by **Misfire** » Wed Apr 21, 2010 1:28 pm

If you are going to replace the rail caps, I recommend swapping them all out. That way you know they are good for 10 years. Just my 2 cents.

12voltjunky · Post by **12voltjunky** » Wed Apr 21, 2010 2:40 pm

I would like to see photos, just out of curiosity.

yeddy · Post by **yeddy** » Wed Apr 21, 2010 3:16 pm

I tried taking some pics, but they didn't turn out too good, couldn't get my camera to focus close enough to see the swelling caps. Most of them have rounding tops and look abnormal. It feels hard under the plastic covers. the amps all play fine with a 10amp fuse. What causes this to happen?

12voltjunky · Post by **12voltjunky** » Wed Apr 21, 2010 4:25 pm

I might be wrong, but I believe capacitor swelling is
an ominous sign that you should go ahead and replace them if
you desire a reliable amp. I probably need to check mine too.

dontlookatme · Post by **dontlookatme** » Wed Apr 21, 2010 8:46 pm

now im scared about all my ti amps too. damn i wish someone near los angeles from the forum lived near me

yeddy · Post by **yeddy** » Thu Apr 22, 2010 5:32 am

There is only 1 screw holding the board in! It should be pretty easy to replace these caps...

dontlookatme · Post by **dontlookatme** » Fri Apr 23, 2010 12:14 am

yeah and there is a shit ton of other bolts and screws holding the seat and plastics to just get to those screws..

someone should post a how to on ti amps so i can check and or replace caps