wire guage to feed BASSCUBE?

Blad09 · Post by **Blad09** » Sat Sep 11, 2010 4:41 am

What size wire is everyone using to power the basscube. I've got 16ga. right now with a 3 amp fuse... is that sufficient?

todd217 · Post by **todd217** » Sat Sep 11, 2010 4:45 am

yes, 16awg big is enough.

opimax · Post by **opimax** » Sat Sep 11, 2010 6:07 am

Probably much more than enough! I am using very thin single stand power style wire , easy to route, takes minimal space. I have felt the cable for heat build up and have not noticed any...Have you read both manuals? there is no specs on this in either manual

Mark

Post by **ttocs** » Sat Sep 11, 2010 6:55 am

they are not current dependant pieces. As long as they are properly fused you have nothig to worry about. Sounds like you are fine.

The Golden One · Post by **The Golden One** » Sat Sep 11, 2010 7:21 am

actually phoenix gold recommends using 16 gauge wire for all of their signal processors so yes your right on target, but i wouldnt go any smaller than what is recommended.

Blad09 · Post by **Blad09** » Sat Sep 11, 2010 7:31 am

Great thanks alot all. Yea I couldn't find anything in the manuals or secrets so thanks again