ti elite crossover

wooferdog · Post by **wooferdog** » Thu Oct 07, 2010 10:13 am

are they below the triangle with three holes?

dontlookatme · Post by **dontlookatme** » Thu Oct 07, 2010 10:24 am

ti600.2

Post by **ttocs** » Thu Oct 07, 2010 10:41 am

below the brushed metal shroud with the three holes in it, under the center window.

wooferdog · Post by **wooferdog** » Thu Oct 07, 2010 4:45 pm

I can only see blue lights towards the top of the crossover but none under the 3 hole triangle.

dontlookatme · Post by **dontlookatme** » Thu Oct 07, 2010 5:06 pm

right thurrrrrrrrr

opimax · Post by **opimax** » Thu Oct 07, 2010 5:30 pm

the manual states they are suppose to flash , no mention of clipping indicators, don't make this old man walk upstairs to find it.

I don't know about the 2 versions????

Mark

EDIT
I made it , little winded but I made it l(j/k)

"Blue LEDs: Blue LEDs within the crossover will
vary intensity according to the musical signal level"

The picture shows a Ti 600.2 powering the pair

"min speaker wire size is 16 gauge"

"for optimal performance we recommend an amplifier that can provide at least 75 watts of continuous power."

xover 24 db,3kHz
5's 250 watts RMS power handling
6's 300 watts RMS power handling

longboard · Post by **longboard** » Fri Oct 08, 2010 8:21 am

tbh the leds are a hack job if you have had one of these apart they are very crudely put in there!!!!

dontlookatme · Post by **dontlookatme** » Fri Oct 08, 2010 10:00 pm

ive never had to open one up but i guess ill have to look inside of it. im giving up on them lighting up and just going to have to display them somewhere not as noticeable in my next install

Post by **ttocs** » Sat Oct 09, 2010 12:14 am

I have an extra, I would be willing to see if it lights up and trade you if it does and is important enought for you.