Zx 600ti thermistor

[Kvab]

Hej.
I was giving this AMP from a friend 3 years ago, hé said it didnt work anymore.So finaly last evening i thought, id have a look at it. Gave it some power, and i startes in thermal mode, so i disampelt it and found out that the thermistor had broken "leg".
So what i need your help for, is some Info about it!
The only thing i Can read from it is C2 88
And it was mounted on the print at R2 dont know if this is any help.

Sorry for bit bad english om from Denmark

Kim

[ttocs]

I have 10k thermistors if they will work but I have no idea what is supposed to be in the amp. We have some other vikings on here that can translate if you need....

[mhyde71]

perhaps a new thermistor... which i Just might have>>>
remove old one and replace w/ new perhaps?

I have a couple different types... think they went into the MS series gear...but they may work in the zx's...? idk that for sure... but maybe someone could chime in and let us know ?? maybe ask eric- or jason- I bet either of those guys would know or valeks1 too i bet!



Or anyways of having the leg on yours reach the board?


AND WELCOME!

[Kvab]

I have taken it off allready. Bur it is broken of right at the thermister. Så the only chance is the glue it. but dont know if that works"". Dont Think i will.
So was hoping someone Can tell mé the data on it, Them i Can buy on, at the local rc"pusher"

[valeks1]

THERMISTOR 2.2K @ 110deg C

[Kvab]

Ok thx very mutch.

[Kvab]

Ok so now tryed calling around, and ended op with more questions!!!
need to know some more about the Volt?
If someone Can sent mé a link to the one i Can order it..

Thx for ur help btw