Crossover Freq

soth · Post by **soth** » Mon Oct 24, 2011 6:34 pm

Hey,

What are your thoughts on a bottom end x-over point on a 406a. The speakers are a 6.5 IDQ's. Right now i've got them at 80hz and was thinking about going down to 65-70hz to see how they sounded. They range from 40hz to 425 I believe.

Thanks

wooferdog · Post by **wooferdog** » Tue Oct 25, 2011 2:52 am

you should be good to around 63hz,i would not go any lower depending on how high your sub goes and the sub level. you can roll off the sub lower then raise the level a bit to blend back in.

soth · Post by **soth** » Tue Oct 25, 2011 3:01 am

Sounds good. Now time to either build some custom rnets or see if digi key or mouser has some already built close to the feq I need.

thanks,

kevin

Post by **ttocs** » Tue Oct 25, 2011 4:39 am

I wonder if it would be possible to solder a pot into one to make it adjustable?

soth · Post by **soth** » Tue Oct 25, 2011 4:02 pm

Prob can, but that's over my head, lol

Crossover Freq

Crossover Freq

Re: Crossover Freq

Re: Crossover Freq

Re: Crossover Freq

Re: Crossover Freq