Zx950 problem

[busterkiller86]

One of my channels is cutting down in volume and distorting at low volume. When I turn it up it balances out with the other channel. I am running 4in tang band active on the channel from ~500 and up. The speakers are 8 ohm speakers. When its working it sounds great but seems to cut down in volume for no reason, and will start playing again when I push it really hard. The channel is from the front channel on the 4channel side (zx450). I have the other side (zx500) running an idq12 at 2 ohms that goes into thermal protect sometimes. I think that is just a current problem, I am only running 4ga power wire to it. Any thoughts would be appreciated.

[ttocs]

the pots are known to get dirty and cause problems. With the power off, first take note where they settings are at. Then move each of the pots 6-8 times back/forth before finishing in the same spot you started. Do that to all of them and see if it helps.

[trickyricky]

I use DeoxIt and works like a charm.

[imo1]

I had the same issue a few months back on my zx450, and turning it back and forth worked perfectly!
(although, i did it about 20 times per pot, lol)