How's it going fellas I'm hoping Simone can shed some light for me. I have a ti21000.4. It was playing fine and turned off all of a sudden. When I give it power the three blue LEDs flash on then off. The front clip light flashes as well. And it makes a slight clicking sound. A red led comes on that say "led 902" right above it I took a video to give you guys a better idea. Thanks in advance
https://www.youtube.com/watch?v=M4D3c0qE-w0
Ti21000.4 help please
Re: Ti21000.4 help please
My guess would be a shorted speaker. Have you tried unhooking the speakers and seeing if it powers up properly.
2008 toy tundra
Kenwood dnx-9980hd
Hertz hi energy 3-way
Hertz hi energy coax
M50 ser# M500001
M25 ser#M2500001
Outlaw x3
Bandit x4
Route 66 x2
M100x3
M44x2
M50 x4
M25 x5
Powercore 15
Ti Basscube
And other goodies
Kenwood dnx-9980hd
Hertz hi energy 3-way
Hertz hi energy coax
M50 ser# M500001
M25 ser#M2500001
Outlaw x3
Bandit x4
Route 66 x2
M100x3
M44x2
M50 x4
M25 x5
Powercore 15
Ti Basscube
And other goodies
Re: Ti21000.4 help please
^^^^What Art stated ...also look for any metal touching metal (speaker wire, power / grnd wire) causing a grounded short ...start from the battery and work your way back to the head unit. It's a pain in the ass, but will force you to double check all connections.
Audison Bit Ten
Hertz HSK163's (x2)
Hertz HX250 subs (x2)
Hertz HDP1
Hertz HDP4
PG Tantrum BassCUBE
XS Power D4900
Misc. PG Install Goodies
"Old-Skool TI-Whore"
Hertz HSK163's (x2)
Hertz HX250 subs (x2)
Hertz HDP1
Hertz HDP4
PG Tantrum BassCUBE
XS Power D4900
Misc. PG Install Goodies
"Old-Skool TI-Whore"
-
- Posts: 1653
- Joined: Sun May 06, 2012 8:01 am
Re: Ti21000.4 help please
I believe in the test video he didn't have the speakers or RCA's hooked up. If it's in protection without speaker wires or RCA's attached then more than likely it will need repair, shorted output/s.
With a DMM check each speaker connections (without the amp), set it to ohms...you should read around 3.6ohms for 4ohm speakers.
With a DMM check each speaker connections (without the amp), set it to ohms...you should read around 3.6ohms for 4ohm speakers.
-
- Posts: 2
- Joined: Mon Dec 08, 2014 6:58 pm
Re: Ti21000.4 help please
Thanks for the help fellas. The vid is with the amp by it self. No speaker wire wait anything connected. And all the speaker wire and speakers checked out fine.
-
- Posts: 1653
- Joined: Sun May 06, 2012 8:01 am
Re: Ti21000.4 help please
Very likely that the amplifier will need to be sent to PG for service...hopefully its still under warranty.