does anyone know the ohm load on the Elite 6.5 drivers?

gentlejax2 · Post by **gentlejax2** » Mon Jul 30, 2007 7:35 pm

I might try a different driver with the xover but I dont know what the ohm load is on the mid in the 6.5 Elite set

Mike

gentlejax2 · Post by **gentlejax2** » Tue Jul 31, 2007 8:40 am

really need to know this....is it on the slim to none owners manual?

Mike

Post by **VW337** » Tue Jul 31, 2007 8:47 am

Do you need the driver or system impedance?

I think the driver is ~4.2 and the system is ~3.6

gentlejax2 · Post by **gentlejax2** » Tue Jul 31, 2007 12:00 pm

I need the driver impedance so if I try out some other mids (Image Dynamics) then I will not fry the xover.....maybe...

of course I need to know the frequencies of the xover and the drivers

Post by **Bfowler** » Tue Jul 31, 2007 12:24 pm

i was trying to pin point a problem in my System not to long ago and the ti mid was either 3.6 or 3.8....(will it make that much difference?)

ericb · Post by **ericb** » Wed Aug 01, 2007 10:13 pm

never add another driver to a passive crossover that's not 6 db per octave. it can screw the frequencies up and possibly cause ringing.