PG Ti Elite 6 comps Vs. BA Pro 6?

Post by **Bfowler** » Thu Aug 23, 2007 7:29 am

^right

sorry, i misunderstood the problem though all the other posts. it certainly wont fix off-axis clarity and add sparkle.

Post by **stipud** » Thu Aug 23, 2007 8:09 am

Mount your tweeters to velcro or double sided tape and move them around. Find the best location for them to image properly. You might have to mount them axially to get best results. You might want to try kickpanels (aimed at the listener), far dash or even A-pillars as well.

Damage · Post by **Damage** » Fri Aug 24, 2007 6:47 am

I tried something last night...I disconnected my rear set of the BA's and left my front set (in the kick and door) only...

One thing for sure, the stereo seperation is better, I believe it sounds clearer, and I know for sure I need an enclosure on the 6.5

I think I may just sell both sets of BA's and get one seriously kick ass pair of seperates in thier place.

I am also building a pair of lower powered tweeter banks for the a-pillars to help with high end clarity.

Any suggestions on what to look at that will completely blow away the BA Pro 60 sets I have now?

jjohan35 · Post by **jjohan35** » Fri Aug 24, 2007 4:54 pm

Dynaudio 360.

Mackenzie · Post by **Mackenzie** » Fri Aug 24, 2007 6:42 pm

Get the elites..

Post by **smgreen20** » Sat Aug 25, 2007 12:15 pm

I'm trying to be unbiased as possable on this topic being that all of us here are PG freaks, some more than others.......You know who you are.

Idealy I would take the tweet from the Dynaudio System 242 MKII and the PG Elite mid. I've owned both, My Dynaudio set was the 240, and I have to go w/the Elites. 2 reasons. 1) being the mib and 2) being the power that the Elites will take.

The tweets on the Dyn set are so much more defined, but the Elite tweets arn't too far behind. If there was just a way to combine the 2 safely for each driver.