component opinions

Post by **VW337** » Fri Jan 26, 2007 1:58 pm

Bfowler wrote:
dcavaudio wrote:RSd6.5 MSRP $99.00 M.A.P $90.00
fyi.
where did you get those prices from?

That is the coax price.

bladestars · Post by **bladestars** » Fri Jan 26, 2007 2:00 pm

If you can, listen to the Hertz lineup. Budget wise they seem very nice on a sound board..

dcavaudio · Post by **dcavaudio** » Fri Jan 26, 2007 3:27 pm

PG direct. Keep in mind these prices are for Coax not the components. I apologize missing the obvious.

twisted · Post by **twisted** » Fri Jan 26, 2007 5:38 pm

i will be running them in a 3 way setup
6.5 midbass 55-1.2k these will be mounted mid way up in the door
5.25 midrange 150-2.2k in the kick panels
and my tweets will be mounted just below the 6.5's @900 up
and 3 10's 40-100

the 5.25 coax's in the rear deck for rear fill

i will be running 2 outlaw amps
1 m50 to the front 5.25 midrange in kicks
1 m100 to the 6.5 components
1 m50 to the rear 5.25's
1 m100 to 3 10" dvc's wired @ 8ohm each in series to achieve 2.66 ohm load on the amp

i will be using 2 30 band eq's and a bass cube

i think with the speaker placment, proper angulation and frequency range of the speakers
it should have very nice imaging after a little trial and error in placment im sure.

and if not i will start all over again