Is this amp enough to power my PG speakers???

[the1obster]

I just picked up this amp for a great price, but dont know much about audio and would like to know if it will be enough to power my front and rears, NO subs at the moment.

Amp I bought is:

ALPINE MRP-F250
RMS Power (at 14.4V THD+N, 20Hz-20kHz)
Per channel into 4 ohms: 40W x 4 (0.08% THD)
Per channel into 2 ohms: 50W x 4
Brigded 4 ohms: 100W x 2

Speakers are:

Front:
Phoenix gold RSD 6.5 components
6.5" COMPONENT SET RSd65cs
SPECIFICATIONS
Power Handling (Minimum RMS/Peak): 5W/120W
Impedance: 4 Ω
Frequency Response: 45Hz - 20kHz
Sensitivity: 91dB @ 2.83V/1M

Rear:
Phoenix gold Ryvel 6x9
POWE R handling (RMS /PE AK): 50W/200W
frequ ency response:
50Hz-20kHz ( V690 )
sensiti vit y 2.83V/1m:
89dB ( V690 )

Also the Deck I am using now is the Eclipse AVN2210 (the one with the tomtom in it):

Power output 50W by 4 (MAX)
RMS power output 29W by 4
Output level/Line-out impedance 5V / 55ohrm
Power supply 13.2V DC (11—16V)
Dimensions (W by H by D) 7inchby 4inch by 6-1/2inch (180 by 100 by 165mm)
Weight 5.5lbs (2.5kg)
Dimensions (PND only) (W by H by D) 4inchby 3inch by 1inch (101 by 76.1 by 23.3mm)
Weight (PND only) 0.4lbs (0.2kg)
Operating temperature range –4°F to 149°F (–20°C — 65°C)
Operating temperature range (PND only) 14°F to 131°F (–10°C — 55°C)
Suitable load impedance 4ohrm

[Ivanfbi]

bridge the amp, 100W should be pretty good, but i would put a little more power if you have some.

[Tcguy85]

bridge the amp and put all the power on the fronts.

they would still like quite a bit more but it'll work.

the rsd's love power.

[Bfowler]

x3 on the bridge your amp to the fronts and run the 6x9's off the deck

[dgoodhue]

x3 on the bridge your amp to the fronts and run the 6x9's off the deck

Agreed. I run my RSD65CS to my M25 and run the Boston Acoustic 6" coxial off deck power. I actually cut the tweeter wire off the coaxials and mostly fade to the front. I really only use the rear when I have passengers or I remove the sub for maxium trunk space.