2 amps, 1 sub

nutxo · Post by **nutxo** » Tue Mar 18, 2008 7:54 pm

Is it really possible to set up 2 amps to run a DVC sub?

Post by **mr tibbs** » Tue Mar 18, 2008 7:56 pm

Yep, many people here have done it with the TI Elite!

nutxo · Post by **nutxo** » Tue Mar 18, 2008 8:00 pm

mr tibbs wrote:Yep, many people here have done it with the TI Elite!

Yeah, but I wanna use a sub with some real output

Post by **bdubs767** » Tue Mar 18, 2008 8:05 pm

YES, but you have to make sure the outputs of both amps are perfectly matched or the VC will get all fucked up.

nutxo · Post by **nutxo** » Tue Mar 18, 2008 8:10 pm

300 watts per VC = 600 watts?

Ivanfbi · Post by **Ivanfbi** » Tue Mar 18, 2008 9:29 pm

pff for 600w you need only one amp

Post by **fuzzysnuggleduck** » Tue Mar 18, 2008 10:59 pm

Yes, if each amp is putting out 300W then you're putting "600W" on the sub.

Make sure you gain match the amps with a DMM. Normally I'd say the DMM is nice but unnecessary, however; In this case, I think it's necessary to do it "right".

MORTIS · Post by **MORTIS** » Wed Mar 19, 2008 3:38 am

That's the problem I'm facing with hooking up a ti500.4 to 2 DVC subs; on a smaller scale of course.
1 channel per VC