Amp settings?

ELmx479 · Post by **ELmx479** » Fri Jun 13, 2008 4:29 pm

I posted in another thread but i'm just going to make a new one..

I set the gain on my ti600 using a dmm and unless I turn the bass level on the amp up to about 1/3 there is very little output with music. Now, I know everyone on here says leave the bass level on the amp down all the way. Is it really that bad to have it where I do?? I'm using a LPL to control the sub level.

Also, I set the gain with the dmm per channel and bridged and one channel is alittle lower than the other but I set it at 49.5 Ac bridged. Is that normal or do I have a problem somewhere?

ELmx479 · Post by **ELmx479** » Sun Jun 15, 2008 6:41 am

Also I would like to set my mids and tweeters gains using a dmm. I believe a 1K test tone for the mids but what about the tweeters? Maybe an 8K test tone?