Qustion about RSD10d.

larams · Post by **larams** » Mon Jul 14, 2008 12:21 pm

I am thinking about getting the rsd10d but have a couple questions about it.

1. Will it be ok to use with an infinity 611a monoblock amp rated at 650 watt rms? I want to be able to use the full 650 watts if I can but the rsd says it's only rated up to 500 watts.

2. Is an enclosure measuring 2.0 cu/ft ported and tuned to 33hz a good match for the rsd10d? I'm pretty much stuck with this box because it was made out of fiberglass and custom fit into my car so whatever sub I get has to work in it. I think it is fine but want to make sure from others who know more than me about the rsd.

Thanks alot.

Post by **Bfowler** » Mon Jul 14, 2008 12:28 pm

the amp will be perfect for it. they can handle quite a bit of power.

what is the port length? according to the manual the box should be just fine

larams · Post by **larams** » Mon Jul 14, 2008 2:40 pm

The port I'm using is 3" diameter and 7.25" in length. That should give me a tuning of 33hz from what I understand. I read 33hz was a good tuning point
for good sql but I don't know if thats true. I figure it's easy to make it longer or shorter if I need to.

Oh yah I forgot to say the rsd I'm looking at is the older one I think. Just making sure in case there is difference with the newer rsd competition sub.

Post by **Bfowler** » Tue Jul 15, 2008 8:15 am

That box sounds damn near perfect, go for it and let us know how it sounds!