rnet crossovers

Need help with your car stereo system? Have a technical question? Post here.
Post Reply
BLACKonBLACK98
Posts: 39
Joined: Thu May 01, 2008 8:48 am

rnet crossovers

Post by BLACKonBLACK98 »

simple question, do the rnet values stay the same regardless of speaker impedance? i've read ohms change the frequencies of component crossovers but i'm not sure if this is the same. thanks.
Top
User avatar
marko
Posts: 2356
Joined: Sat Dec 23, 2006 11:30 am
Location: England

Post by marko »

yes they do, it'a active cross over so before amplification so speaker load has no influance on pre amp processors.
Ti1 headunit (unique)
Outlaw in crate.
2x original shrouded ms2250's.
Route 66 in box + custom m100 to match.
Roadster 66 in flight case
Octane LE in box.
Reactor #186 in flight case.
Reactor EQ232
Ti400.2 AL
AX204A + EQ232 + ZPX2 + TBA set
ZCS6 component set
Tantrum+Titanium bass cubes
Ti12d Elite sub
DD5 + DD10 + 6 Ti blocks!
Top
BLACKonBLACK98
Posts: 39
Joined: Thu May 01, 2008 8:48 am

Post by BLACKonBLACK98 »

thanks. that's what i figured after i took awhile to think about it.
Top
Post Reply

Return to “Car Audio”